Tuning your Hpi trophy truggy 4.6 good performance and a good running temperature 👍🚗🚙🚙🏎

This video is a how to easily tune your nitro this engine runs at 230 degrees Fahrenheit I run it just below that but I wouldn’t recommend over 230
Some engines run at different temperatures so make sure to read the manual just to double check
If this video helps you out which I hope it does leave a comment and don’t forget to
Subscribe
And thanks for watching and for your support 👍

[@dadruben4680]

Thanks for that, but the engine is warmed up, or cold?

[@danthercman]

I didn’t have a engine heater on that day, but if it’s cold strongly recommend getting engine heater or some sauce of heat always best to preheat engine before starting, in the summer time you shouldn’t need a heater as much that’s up to you. If you don’t use a heater the engine parts will wear out faster.

[@dadruben4680]

Thanks for that. To find the right setting of the lsn the engine is hot, right?

[@danthercman]

@@dadruben4680 don’t start any tuning adjustments till 200 degrees but if you need to make adjustments on LSN then you can but don’t touch it if you don’t need to, LSN needle must be between 3/5 seconds for a good LSN setting.

[@dadruben4680]

Ok, that helped a lot. Thank you