Turbo Charged Printing Head V2.0

[@zk_6312]

Looks good. Will this fit ona Microswiss direct drive back played. You should put a couple of leds in the head.😂

[@raatzie]

Awesome video, the new design looks excellent.

[@DesktopInventions]

Thanks! Glad you like it!

[@MallocArray]

Looks like it wouldn't support the CRTouch since the cable comes out of the top instead of the side, very near where the screws go.

[@DesktopInventions]

Yes I see that now. Shouldn’t be too far off. I’ll have to purchase a CRTouch and see what i can do.

[@Zemistr3D]

00:30 The print quality is really bad. :/

[@sanninoftheleaf9700]

It never got better

[@Zemistr3D]

@@sanninoftheleaf9700 My prints looks much better 🤷‍♂

[@DesktopInventions]

Yea I was in a rush and printed this at 120mm/s definitely not smooth with the harsh lighting on it. I may have to reprint a better looking version, and see if there’s any other problems going on as well.

[@Zemistr3D]

@@DesktopInventions Yeah. I start using 0.6 mm nozzle for most of my prints on the Ender-3 and the quality went little bit down too. 😅

[@wow_gaming_time4208]

Good video but do you think the adjustable part could move and then in turn move the bl touch up or down messing up your z offset?

[@DesktopInventions]

Yes that’s always a possibility. Maybe I should think of a way that the BLTouch is mounted to the back plate for a future design

[@gabenite]

Do you have a link to the y harnesses, soldering is not my strong point

[@DesktopInventions]

I’m not sure how to buy the Y harness with fans connected already but you could use something like the wago connectors or cold wire splices here to splice without soldering. They’re a little bulky but can work.

[@DesktopInventions]

www.adafruit.com/product/866?gclid=CjwKCAiA5sieBhBnEiwAR9oh2jUrbpYVRV3THtZ65cTLQ141OIl8rO-slQygUj6Be1LRDUBAuFY78RoCv0IQAvD_www.adafruit.com/product/866?gclid=CjwKCAiA5sieBhBnEiwAR9oh2jUrbpYVRV3THtZ65cTLQ141OIl8rO-slQygUj6Be1LRDUBAuFY78RoCv0IQAvD_BwE

[@dotintegral]

Wow, my comment made it to the video, cool!

[@DesktopInventions]

Absolutely! I appreciate all your comments 😃

[@sw4tcz]

which filament? (I have only pla+, but i guess it needs petg)

[@DesktopInventions]

Currently mine is printed in PLA

[@stefanguiton]

Awesome mod!

[@DesktopInventions]

Thanks for the support!

[@AndrewAHayes]

The print quality on those parts is rough, it looks the same as when I had bent leadscrews on an Ender 5 Plus

[@DesktopInventions]

Yep I’ll be looking into what’s causing that once I’m back from holiday