Tutorial: Adaptive Milling in NX CAM

[@mayahttformerlylmgi1628]

Great tutorial! Would you adjust the step over feed to reduce the cycle time?

[@heronguyenvan9686]

Awsome

[@1186MFG]

I love nx. I really do. But this is so painful.

[@MrJohnnyFred]

This toolpath would take about minute to setup in Mastercam...

[@supahonkey]

NX CAM: Making easy things hard. I love NX too and have used it since version 4. CAD is spot on, albeit difficult to use if you're new to the software. NX CAM is whole other level of 4x the clicks to do something simple. Inventor CAM and Fusion CAM suck for complicated parts, but they sure do make 90% of the normal stuff much easier to do in CAM than NX does.

[@1186MFG]

@@supahonkey that was my point. . .