Twin Timber 1.6m Programming for Full span Ailerons

So here we bind up and get the Full span Mixes in the radio. I get the wing on and have a flap issue witch I figure out later. Seems like i got the bad Plane out of the batch.. This one the servo horn was in the wrong location so had to remove a brand new servo from a new plane. I got it where needed but then the trim seemed to keep changing on me, I finally figured out the plastic housing for the Servo itself wasn't glued to the plane well so i had to pull it out and glue it back in..
Now I hope everything is good. Maiden tomorrow if all goes well..
I am having one issue I didn't see till later on or i would have gotten it on camera. I think its just something crazy in the Channel Assign page or something. It won't let me Inh the Gear channel 5 or the right flap just goes down. so its on my Bind Button so i don't hit it by mistake in flight. but when i hit it just the Right flap goes all way down. I never had that happen on my old Timber X's with Full span..
I have aircraft type set for 2 flap 1 Aileron. But not sure.
Thanks for watching.