Nice video. I've done several pipes for 2 stroke mopeds without sheet rolling machine and its quite a big job to form these cones with bare hands, hammers and some dies. Im dreaming to buy a rolling machine like yours.
@jomi0087 Жыл бұрын
There pretty cheap believe me 120-200 bucks and it‘s yours
@pkuula Жыл бұрын
@@jomi0087 Some months ago I purchased one small rolling machine but not yet used it for pipes.
@timdryden37783 жыл бұрын
learned a lot. THANKS
@itiswhatitis38392 жыл бұрын
A longer lever handle will help roll your cones with less effort and force applied
@jadymulqueeney2 жыл бұрын
Great thanks
@liamsnowman8030 Жыл бұрын
Great vid, need help! Do you adjust the top pin at all or always leave it in the same position ? Im struggling to roll some cones for my exhaust, as i adjust the lower "shaping pin" and bring it up wards, after a while the cone gets so stiff i can't slide it through one side more than the other as you show.. any ideas ?
@johnpetersen82382 жыл бұрын
Wow, very interesting.
@oo.llpee.74574 жыл бұрын
How thick is that metal? Do you think it's possible to get decent cones just by hand, when using 0.8mm sheets (21 or 22 gauge)? I saw video, where they used hose clamp to get good shape...but of course I would need to get it pre-bent before using clamp.
@rajalarasmus2 жыл бұрын
Yes I am doing 1mm sheet and decenting it by hands
@vGaming-bq9ni3 жыл бұрын
I'm 17 years old. How i wish. When can I have my own tune pipe. For my old Yamaha L2 2stroke. 😔
@humofthehive71553 жыл бұрын
What slip roll is this? I have been looking for a small diameter roll, this one looks more sturdy than some of what’s on the market.
@done-wright_performance Жыл бұрын
Woodward Fab 12″ Length Slip Roll is what it looks to be. $300 after shipping and taxes.
@Alexie33333 жыл бұрын
wow Thanks for usefull tips
@codyflowers98042 жыл бұрын
I have a question on some pipes I got on a PSI 1004 cat. I heard you guys could possibly help and your from Michigan as well
@sped493 жыл бұрын
nice video
@magnatron77343 жыл бұрын
Great vid, where do you get the exhaust ends?
@AustinLeeckRacing3 жыл бұрын
Wahl brothers racing sells them
@rabinapierrevincent30023 жыл бұрын
What kind of steel is that using Sir.?
@haircutboys2 жыл бұрын
that answer is in the 1st video kzbin.info/www/bejne/j4O7nayah52jasU