Two Tone Powder Coating How To

[@TH-qf1en]

Freaking awesome job! I watch Steve morris can’t wait to see what his shop has up there sleeves for this setup!

[@710performance]

It’s gonna be awesome! He has a video coming in a couple weeks 😁💪

[@jerryhatrick5860]

Tedious work. Not cheap. Skillz. Very nice work.

[@710performance]

Thank you 💪

[@4legdfishman]

Nice looking valve covers! I'd love to see the motor complete!

[@710performance]

Thank you 🙏 Steve Morris Engines will be uploading a video of the build in the coming weeks.

[@glynecollymore5569]

Can I ask where do you purchase the high temp vinal

[@710performance]

It's just regular vinyl I get from US Cutter. It's not in the oven for the full cure, so I've never had any trouble not using high temp vinyl.

[@glynecollymore5569]

@@710performance thanks for that

[@710performance]

@@glynecollymore5569 no problem! glad to help!

[@rafiekahmed8568]

I awesome videos i keep watching your videos over and over again i have one question how many minutes minutes is the partial cure and at what temperature do set your oven Thanks in advance

[@710performance]

If a full cure is 10 minutes at 400° part temp. Then get the part to 400° then wait 2-3 minutes. Partial cure is done.

[@WilliamCotton-dl2yp]

Great job!

[@710performance]

Thank you 🙏

[@MyOyvind]

You are the master

[@710performance]

Thank you 🙏

[@jayb1itz15]

Nice work bro 🔥🔥, how did you keep the red off the blue once it was partially cured?

[@710performance]

Thanks! I vacuumed it off, and the vinyl helped too

[@iPrint3D]

Heck ya!

[@710performance]

Thank you!