Two Trees TTC 450 - Installing X axis Nema 23 motor

[@dominikmusinski9580]

Hey, I've been following your progress with the TCC450 upgrade for some time now. I think I'll have to do something similar. Does replacing the motors with nema 23s also involve replacing the entire electrical system? i.e. the motherboard, motor controllers, etc.? or can I just swap the motors? Greetings from Poland Dominik

[@vAzhureThings]

hi ✌ youn need a new external motor drivers at least. You can use original board, but existing current is not enough for Nema 23 gl ✌

[@dominikmusinski9580]

@@vAzhureThings Thanks. So if I buy a GX80 which has a nema 23 motor, will I need to buy a driver and power supply for it to even work with the ttc450?

[@flosscap]

What sized rails are those?

[@vAzhureThings]

HGR15 ✌all data disk.yandex.ru/d/q5rXIguhThlySw

[@8mmmauser896]

Are you willing to share or sell the files?

[@vAzhureThings]

disk.yandex.ru/d/q5rXIguhThlySw

[@zhuk462]

Could you show how to fix backslashes?

[@vAzhureThings]

I replaced nuts.

[@zhuk462]

Not usual TTC 450. Mine is different.

[@vAzhureThings]

Yep, a lot of my modifications