Tyco Rebound 4x4 battery upgrade, super easy less than 15 minutes

[@Joeydamelio]

This is great

[@lukemagook]

I'm not good at this stuff but this looks manageable. Forgive my terminology. What are you screwing the new wires in to? From the video it looks like you're just screwing them into the plastic body. But clearly you're hooking them up to the motor... Also, how much run time do your get Is the orginal power reduced at all How do you recharge the battery?

[@Dudsy973]

the pigtail power connector wires are just attached with small screws screwed into a small gap where the original power connectors mate to the original battery, match the positive red wire to the positive side (marked on the body I believe? I used the smallest 7.4v 800mah lipo battery I could find. charging is with any charger that charges lipo rechargable batteries

[@lukemagook]

​@@Dudsy973 it worked great, thanks! Next in going to try and figure out how to gut one is the nicd battery packs and fit a li-ion inside. Any advice there would be great!

[@yzfr1too]

I’m crack open my battery pack n put new lithium in it run fast fast now.

[@lukeout7284]

Hey, I'm planning on doing this. Can you share how you did this and what batteries you used?