Ultimate Fire Safety Hack: Make Your Own Arduino Fire Detection and Extinguishing Device

[@neergala3639]

Do you have the link for the nozzle?

[@tejeswaramaharana7995]

Mast video bro

[@ankithatm6902]

Can u tell me which programming language u have used to write the code?

[@PottimutyapuLikhitha]

What is the application of the system and where it is used

[@AbhimanK-n8z]

Dude By mistake I bought IR module instead of just ir flame sensor Is there any issue?

[@TechieLagan]

No issues

[@AthaziaAshleyDasco-vm1mv]

will it affect the result if we just follow the circuit diagram but don't cut the breadboard in half?

[@TechieLagan]

No it will not affect the result.

[@AthaziaAshleyDasco-vm1mv]

Thank you so much!

[@TechieLagan]

My pleasure

[@creative_arts_22]

Hello bro

[@TechieLagan]

Hlo brother

[@mukeshdalai6187]

Good work bro

[@TechieLagan]

Thanks bro

[@angelaraymundo700]

How long are the jumper wires?

[@TechieLagan]

The ones I am using is around 7-8 cm.

[@angelaraymundo700]

​@@TechieLagan also about the breadboard, does it need to be cut in half?

[@TechieLagan]

No no, I have done that because my nodemcu was a bit bigger in size, it was not getting fit to the breadboard.

[@angelaraymundo700]

@@TechieLagan thank you very much(⁠◠⁠‿⁠・⁠)⁠-⁠☆

[@TechieLagan]

My pleasure

[@sathwikgaming4698]

Hello can we do this without breadboard

[@TechieLagan]

Yes you can

[@sathwikgaming4698]

Bro can we do coding from phone with arduino droid app please

[@sathwikgaming4698]

How to do this without bread board I buyed all components please how to do

[@TechieLagan]

Yes

[@TechieLagan]

Just connect all the components as shown in the circuit diagram