Detect discontinuity center of shaft with longitudinal wave
Пікірлер: 13
@siavashshakoori65552 жыл бұрын
Very good
@siavashshakoori35292 жыл бұрын
Professional
@gj_khan57592 жыл бұрын
which standards you follow for this
@mortezaltfi Жыл бұрын
Sa388
@mukeshrajak17894 жыл бұрын
What is test standard you had followed?
@mortezaltfi4 жыл бұрын
this test only scanned and detected defect but when we want interpretation defects then use A388 standard reference that include two procedure and to sensitivity method ( DGS.DAC) and in this standard has acceptanc critical for two method furthermore We use of DGS curve that is especially for each probe
@haribabuampolu5741 Жыл бұрын
What is the possible reason for these detects? How to interpret this kind of defects?
@mortezaltfi Жыл бұрын
This defect acurred in center of raw material .in fact I was cut the shaft in two side then I could see a linear defect in center of shaft .meanwhile in this video only I detected the defect. I don't say anything about the result of test.
@vignesh.d87323 жыл бұрын
Accepted or not ? This type defect
@mortezaltfi Жыл бұрын
Accept
@aritan95642 ай бұрын
@@mortezaltfi it accepted... so how the indication of rejected..? is it depend on % FSH or what..? thx bro..