Unboxing and Setting Up the WEN DPA2513 24"x12" Drill Press Table

Рет қаралды 2,512

Valentech

Күн бұрын

Пікірлер: 17

@sdangelo6 Жыл бұрын

I have the same set up, but I can't figure out an easy way to square the table to the drill press

@ValentechTime Жыл бұрын

Did this video help? What drill press do you have?

@sdangelo6 Жыл бұрын

The same one you have if you trying to drill holes in the center of a board, you need the fence parallel to the truck and there’s no real easy way to find that alignment so I thought you might’ve had a solution to that I will come up with something one of these days

@sdangelo6 Жыл бұрын

Parallel to the chuck sorry

@ValentechTime Жыл бұрын

@@sdangelo6 I am not sure if i understood the description. Fence parallel to chuck? I believe if chuck and fence both are perpendicular to the table, then fence is parallel to the chuck. Tools like right angle and/or air bubble level could help to find this out. Please share when you find the solution.

@chaineffect6437 Жыл бұрын

i may be interpreting the problem wrong as well but, could you mark out the center of the table, then chuck up a straight piece of rod, set up a square on the center of your table and move the table till your square makes contact with the rod. of course you will have to account for half the thickness of the rod used for true center.

@herbsu4330 5 ай бұрын

Was there some reason you skipped installing the table onto the drill press or did I miss it?

@ValentechTime 5 ай бұрын

I did not skip it, the video shows the process from start to the end. I am not sure how you could miss it. You might want to try watching again.

@herbsu4330 5 ай бұрын

@@ValentechTime I watched it again and do not see you attaching the underside.

@ValentechTime 5 ай бұрын

@@herbsu4330 You are right, I did not show the actual process of installing clamps that hold this table to the table of the drill press. But I show how those clamps look like at 2:57 until 3:05.