Underwired bra draft in an open-source pattern making program Valentina/Seamly2D

[@JamesSavage-b7l]

I would like to thank you for your video. It took me while to work out how to use the program but I finally got there. Your video was very helpful. Thank you again.

[@VeNove]

Thank you, I'm glad it was useful for you.

[@kassijam6991]

Hello, thanks a lot for your explanations, would you please explain how to mesure bust height, I am a little bit confused, is it from bottom of the neck at side to the nipple?

[@sierraaaaa]

Please make a video on what each measurements they are.

[@mandelish]

What do you mean? If you don't know pattern drafting at all you must use some sources because there are specific guidelines and formulas in the process. These go into Valentina to get the lines or curves as a matter of fact exp. drawing panties pattern waist line formula is (waist/4) *0.9 ---> divided by four because you draw a quarter of the piece only ; multiplied by o.9 because the fabric will be stretch for panties and you need to account for that. Even for different stretch you will have slightly different value. You need resources and unfortunately it is not that you can sit at the computer and draft clothes without any knowledge. I don't say that it is very complicated, it is not, but a lot goes to it ...really a lot...

[@yuliiakushsh]

How i should mesure "chest height"?

[@VeNove]

Chest height refers to space between the chest and the underbust at the center front. To measure it, tie one string or tape at the underbust and the second at the chest (over the bust, above breast tissue). The chest height is the measurement between the two stings in the center front.

[@tamilarasan6855]

Need molded bra pattern drafting video.