There are lots of videos of drums Sterilising mushroom spawns but never mentioned what they do to mushroom . Can you please give a brief explanation what it actually do and is it done before planting? For a beginner , even this leaves us with questions
@Shanesxperiments4 жыл бұрын
where can you buy a similar size pressure cooker instead of the no-pressure style?
@johnwheeer7619 Жыл бұрын
So wait are they sealed or not?you said they were before hand.then you said they are only sealed a little bit?
@lololollaughatlife14315 жыл бұрын
How is the square sterilizer coming? Really considered getting a 130 gallon bubba barrel but I think the loading and unloading you brought up- really makes me rather invest in a square one instead.
@TheFriendlyStranger75 жыл бұрын
Hey Eric. What was the reason for the top bags being sealed and the rest not? Is this due to them being closer to the vent and therefore more prone to contamination during cooldown?
@steelersrock3005 жыл бұрын
the top bags are grain spawn which needs to be more properly sterilized because the mycelium will be just starting off in the grain. the rest are bulk substrate and itsmore convenient to leave them unsealed as inoculated grain will be added into the bags in a more mature state.
@TheFriendlyStranger75 жыл бұрын
@@steelersrock300 Thanks!
@fantasyyy_3 жыл бұрын
@Xavier Ruiz I’m looking for this answer too. I would assume so
@semtexzorz94536 жыл бұрын
Is 20 hours necessary? I'm thinking so because it's a vent to atmosphere and not a low pressure...1-2 psi sterillizer. Have you tried running after the warm up at 12hours or less?
@MyersMushroomsFarms6 жыл бұрын
Its because its low wattage, it takes 12 hours just to get to temp. only 2000w heating 400 lbs.
@semtexzorz94536 жыл бұрын
Myers Mushrooms 12hrs to reach temp and then 8hr sterilisation? I guess that's not too bad for eliminating pressure and the worries that come with..
@zorankospic62434 жыл бұрын
Hi! whether spore green molds (trichoderma) are destroyed by atmospheric sterilization. How much time?
@mattallen44653 жыл бұрын
Just to verify for this sterilization process, you need to seal the bags before the sterilization process,since not under pressure and easier for contams to get in? Also have you experienced bags pop with this method?
@raulduke32372 жыл бұрын
No, you dont seal until after, the bags will pop if you seal them
@robshanks40563 жыл бұрын
So what time would you wanna run it at for grain spawn?
@bradford.champlin4 жыл бұрын
Hit the ground runnin' lol. Great vid Eric. Any news on the square sterilizer coming?
@MyersMushroomsFarms4 жыл бұрын
Actually just got a quote today on the first unit, turns out they will be a bit more than expected but for 200 gallon capacity it should be well worth it.
@bobfitz78863 жыл бұрын
@@MyersMushroomsFarms did you ever make a video
@sarge5236 жыл бұрын
How has dry bagging your spawn been working out for you? You're just putting the water and millet into a bag and steaming it all together right? There isn't any excess water or anything afterwards?
@chuckisnutz6 жыл бұрын
How did the square sterilizer shape up?
@MyersMushroomsFarms6 жыл бұрын
First unit will be finished this month.
@woodville88736 жыл бұрын
Thanks for your videos! How many bags can you fit in your drum?
@MyersMushroomsFarms6 жыл бұрын
Woodville 85 gal sterilizer fits around 330 lbs of wet sub
@lorenzogiglioli79246 жыл бұрын
hi eric.. are the filters on the bags wet when you take the bags out? thanks
@MyersMushroomsFarms6 жыл бұрын
Yes they are damp
@joshjewell19606 жыл бұрын
Is it possible to sterilize grain spawn in jars in one of these barrel steamers?
@MyersMushroomsFarms6 жыл бұрын
Yes i have seen jars ran in these drums. The cycle time would be shorter too since the jars heat up quicker and its less total weight in there.
@jammyfindlater3 жыл бұрын
Does anyone know if you can use these bulk drum sterilizers for sterilizing grain spawn? Or are they only used for bulk substrate?
@MaxS535 Жыл бұрын
you CAN but you either have to use the bags quickly, or run the cycle longer.
@howsitgrowin4 жыл бұрын
hey dude.. do u sell those big barrel looking steamers online by chance? If so.. i wanna buy one. Not kidding. Very very serious.
@MyersMushroomsFarms4 жыл бұрын
yes bubbasbarrels sells em
@howsitgrowin4 жыл бұрын
@@MyersMushroomsFarms Thanks bud!
@MyersMushroomsFarms4 жыл бұрын
@@howsitgrowin I also have other videos if you want to build one yourself
@gildedliliesmusic6 жыл бұрын
Eric, why did you lose one of the spawn bags?
@MyersMushroomsFarms6 жыл бұрын
Mike Davidov you need to pre seal and I didnt
@sawyerpannell96955 жыл бұрын
Rather than goes through all this trouble and money on sterilization machines and so forth has anyone ever attempted to cold water lime pasteurize sawdust/soybean hull substrate for spawn? Would love to hear if anyone has ever tried this. I seriously think it would work, probably would just need to let it sit longer in the lime water than straw. Let me know please if anyone has tried this.
@familyfungi4 жыл бұрын
Substrate would be overhydrated, have a lot of nitrogen, and contaminate 100%.
@sawyerpannell96954 жыл бұрын
@@familyfungi I've done it before, have to strain it super well. Can be a pain at times but works
@jordanmercier36164 жыл бұрын
@@sawyerpannell9695 it's just not reliable enough for a commercial setup.
@a1moshe4 жыл бұрын
hey there. I'm currently developing a room I get to use for work and I want to put in a drum sterilizer, but its all regular 120v connections. What can I do to run the drum? I know they require 220
@ExemplaryLigas5 жыл бұрын
how many bags can your drum sterilize? i m interested on buy one, do you sell that drums?