Upgrading our air compressor || Replacing a bad motor and installing the air compressor

[@slugtheslayer]

Nicely done sir and thank you for the video 🧐👍

[@Hereatthehouse]

@@slugtheslayer thanks glad you like it

[@aesthetixxrose6342]

Amazon for the win!

[@g.simard854]

you could have reverse your pulley on the motor shaft, puttting the taper bushing on the inside. Drive belt can support 1/8 of misalignment per foot of span (centre to centre of both shafts).

[@papalilburn]

Shoulda went to Harbor Freight!

[@Hereatthehouse]

I have learned since I made the video that the colic is called a taper lock

[@XPFTP]

few vids on quiting it down. tho simple and easy. gallon can hole bottom hole top. screen in cetner stuffed with foam or ins. set on inlet of pump. done deal. you set it outside.you will have to get a dryer for the air. the amount of water will drown a rat. the can thing i seen worked like a charm. i was suprised. thought here we go again another crap video

[@Hereatthehouse]

@ Thanks for the info I will look into it

[@jasonraines3046]

Ill just use your compressor and let mine rest 😂

[@Hereatthehouse]

@@jasonraines3046 any time there’s plenty for both of us

[@johnmolnar2957]

the laminations in the field are not what's important , did you actually measure the windings to ground? also that is totally the wrong plug set, it is the wrong voltage , and it's not rated for the HP you are pluging in . bad advice . also that panel looks like a sub panel, but you have grounds & neutrals tied together. do you have the bonding screw removed?