User Frames and Tool Frames in Fanuc Roboguide

[@bernardotellezgomez3567]

Thank you very much, yo dont know how important was your information, keep helping the community!!!! You have a new subs

[@mahmoudgabr5531]

thank you man , you are better than my University.

[@MatheusOliveiraEdits]

Thanks my friend, i am from brazil , and here not a lot study material for roboguide, and your videos helpme

[@Jrchivas99]

Great demonstration, thank you for sharing.

[@derina.maleek9408]

I finally understood robot positioning thanks

[@gregmasters7420]

Thank you very much for the tutorial. I notice that you moved the Robot in User mode even though you had a Tool. I have a question about this. It appears that when you rotate/jog using Rx, Ry, Rx in Tool mode, the rotations are different than if you rotate/jog in User mode. I guess this is because in Tool/jog mode, you rotate in the Tool Frames orientation, whereas in User/jog mode you rotate relative to the User Frame. The question is, when I write a TP program, how do I specify what mode I will use to go from one point to another?

[@ceilingwalker1]

Thank you! Love your videos!

[@anastasiasnitko7595]

very clear! so helpful, thank you!

[@derina.maleek9408]

Thanks

[@derina.maleek9408]

Thats my third comment without i know it is my third great vidoe

[@williamhuang5329]

Hanzhen harmonic drive gear , robot arm gear , over 30 years experience

[@pauloyoshizaki2103]

FANUC - ROBÓTICS - AUTOMAÇÃO : Hoje - Tudo - Robótics - Presente - Futuro - Sempre -Fanuc - Robótics : Ano : 2030 : Ano - Robótics - Fanuc - Global .