Using Hardware Effects Pedals When Re-Amping - Supported By Antelope Audio

[@Axewarriorz]

Excellent as always guys.

[@BigHairyGuitars]

Hey guys. I’m thinking of getting the Antelope interface. Would you still recommend it?

[@KeithMilner]

I have messed around with re-amping in the past, on consumer end kit. It's a lot of fun. Yes, it requires a lot of routing flexibility, but I get that in software using Jackd (using either Ardour or Mixbus32c as DAW in this case, but any DAW will do). The hardware I experimented with were mainly Roland/Boss stuff as, at the time, they seemed to be the only one doing wet/dry recording options on their kit: the Vstudio 20, the GT-001, and the Katana. But I have also done some re-amping with the Behringer XR18 for S&G.

[@theejpp]

To clarify, I can record direct into my amp, into the DAW, and then reamp through my board to add reverb, delay, etc. to taste in real time? If so, I'm assuming that they would all be in the "fx loop" of my amp so to speak, since it is being recorded after the signal has hit both the pre and the power amp section of the amp? So it wouldn't make sense to try to reamp and add gain, only wet fx?

[@stevemiell4555]

You lost me there guys, very impressive none the less!

[@billyboy65leath84]

Suppport?

[@LocationRecordings]

Support = Antelope Audio helped pay for the video.

[@AndyDrudy]

Wow! Why not just throw a mike infront of an amp!