Using the Skew Probing Cycle on Your Hurco CNC Mill - Hurco CNC Training

[@tobiask.6605]

This is very useful! I use this probing cyclus quite often

[@tomryan7794]

Curious to know if you can skew the Z-Plane? I have to rework a casting and rather than tapping it flat with a hammer all around, within .005, it would be great if the probe could come down, touch off on Z around my already machined face, and set a Z plane.?.

[@hurcousa]

Hi Tom, unfortunately you wont be able to skew the Z-plane.

[@mikej9297]

very helpful

[@davidbellardo9791]

I just snapped a probe off last week that was 125 bucks lol

[@aaronward3882]

That happens to the best of us.

[@icarus_ap]

it normal cost me about 40 for a new probe tip