UT Angle Beam Calibration Using IIW Type 2

[@floydarmstrong8212]

Please John make a DAC video and reiterate why we even need the DAC when doing ASME. I understand that we need to know how the indication acts at different depths. But I’m struggling with building them and also understanding why we would need it.

[@samardhool5436]

Impressed by you john

[@arifbugga7186]

Please do calibration phase array straight beam for 0.14 inches to 0.06 inches using epoch 1000i

[@jeremystatham5613]

The side drilled hole should show a depth of .600” at calibration, should it not?

[@jamesthrower6415]

AWS on/off before calibration and after?

[@professorgreen1215]

should you check your index point and your agle before calibrating? because if your agle change the pathway change and need to recal again. am i right?

[@rubiselcuba]

Agree..

[@erikgriffith3263]

Not really. This is the whole reason that they are radiused so you could cal a 70 degree wedge or a 45 on the same surface. The 0 degree hash is the center of the "circle"

[@Gukworks]

This was a questuon on B cwi exam. Not sure if I got right:(

[@ABLE4DUBKAY]

Why 2 and 4 inches? What is it reading at 2? Shouldn’t it be 4 and 9 inches?

[@johnreid2691]

This is Type 2 block, it has 2 radiuses one at 2" and one at 4". The 4"-9" is Type 1 block