V1 Engineering Lowrider 3 CNC Test

Testing the Lowrider 3 CNC I printed and built. I spent the last few weekends leveling and squaring the machine.

[@Runslik3Wind]

how is it? I'm thinking of replacing my xcarve for this but as a 4x8. " I spent the last few weekends leveling and squaring the machine." how difficult was it getting set up right and do you think it will stay calibrated?

[@SATXDIY]

I love mine. It wasn't too hard to setup. Not sure how level it is as the table I have it on flips down for storage. Couldn't afford an xcarve so went this route.