valve guide removal and install

watch as I remove a worn out valve guide in this VW air-cooled cylinder head and then the procedure I have to go through to put a new guide in I know that other people do it differently this is the way I was taught and I've always done it this way since then and no I do not have any problems and I've probably done this about 2,000 times with probably a couple hundred sets of vw heads over the last 20+ years.

[@keeledover4218]

mr made on where you located i’m in san diego i bought a. new engine in LA and the guy didn’t bother to clip on the valve train it cause the valve wear the guide i think because i’m shooting oil out my exhaust and also burning oil need help thanks

[@michaelknight2897]

What reamer did you use? Can you link it?

[@evilbeetlekustomscreations4965]

Can you ream a set of linkpin spindles if they were mailed to you?? Been a fan of low budget racing since pinks 😁

[@mrkadron]

Sorry I do not have the tools or experience on those but check Brian Roth in Orange CA, I think k he offers that.

[@evilbeetlekustomscreations4965]

@@mrkadron ✌️😊

[@keeledover4218]

mr kadron sorry typo