Vapor honing some dirty ex400 engine cases and carburetors from a Kawasaki kh400 . As always, check out our website for more info www.njvaporblast.com
Пікірлер: 13
@alanbrown1563 Жыл бұрын
how do you stop the glass beads blocking the tiny holes an jets
@motoblast3574 Жыл бұрын
You can plug them. I just flush them out out with high pressure clean water and air
@savagehandzzz31538 ай бұрын
How are you hearing up the solvent?
@rrickmason66510 ай бұрын
Ballpark cost for single cylinder 2 stroke engine cases?
@heydonray9 ай бұрын
What are you using to heat your degreaser? Thanks.
@barenekid9695 Жыл бұрын
Air spinning ball bearings Damages them !!.
@motoblast3574 Жыл бұрын
I’m sure it can. They also get damaged just from use. They also get damaged from slightly used motor oil. In most cases, these bearings are in much better working condition than when they came in. Most of the time I find metal shavings that get stuck in the grooves due to dirty motor oil. Thanks for the tip.
@chuckflitton5293 Жыл бұрын
what is your hot degreaser solution?
@motoblast3574 Жыл бұрын
Just simple green
@tylersvensson44682 жыл бұрын
Hey man what kind of fibre glass do you use and grit as from seeing other engine builders they use 90 psi in a dry blasting cabinet then using a low pressure in the vapour blading cabinet using a very fine fibre glass to get a chrome look but I’m on a real low budget and can get a used vapour blaster for the size is need for 1000 new from a local business
@motoblast35742 жыл бұрын
I’m not even sure what size glass bead I’m using. I can get a much more polished look if I wanted to, but most people want an OEM look.
@axisvaporhoningindustries43122 жыл бұрын
No 13 is what most are using
@ewatmachineworks19257 ай бұрын
Good day sir, I just want to ask what kind of sand do you use in your sand blass, thank you sir