VBar 5.2 - Episode 19 - Phase sensor on Mini

[@zeemanjr]

Thanks for your videos Mr Mel I use them to setup all my helis the way you explain. Keep up the great work and keep the vids comming

[@mde036]

Thanks for your video of the phase sensor on mini stabi vbar 5.2. I have some questions. I have a futaba r617fs and all channels are used in the vbar (except rx1 and rx2). As shown on the video how can I put the white cable of the sensor in rx A (which is already occupied). Using Rx-1 is no problem. What about this max 6 volts. I use 6 pack lipo and have a bec in my esc but no separate bec. Is this ok.

[@scrc511]

Hello Mr Mel, I ordered this especial wire from Mikado to work with phase sensor. I'm using Futaba sbus and its wired directly to RXC into the Vbar. My question is if I go with your connection using a y cable, where do I plug the Esc? Is it directly to the receiver port on channel 3 or directly into the Vbar in RXB? Thank you Mr Mel.

[@metallica944]

Can you pull power from the Bluetooth adapter port on top to power the phase sensor?

[@kachur777]

iam using a spectrum with a seperate bec going into c how would i go around that, use a y harness for my bec and my sensor together or is there another way iam running my servos at 6v

[@itsusatst20]

hi, im using koni 80+ and spectrum sats, also using a 4s AAA enaloop pack into rx C for backup, can i just loop off the enaloop pack for the phase senser, ? Also what advantages would i get from govening this way in the vbar(i have 5.2 pro) instead of using mode4 in the jive. many thanks :)

[@chriskelly7606]

I know this vid is years old, but are you saying that you only need to do this little mod IF your running more than 6v? I'm planning on putting a mini V into a goblin with mini servos, and a talon 90. the BEC is 6v i think so i'm thinking i wont need to worry about any of this? Please let me know. :) Cheers

[@dspad]

using a silver line do i need to set down the volage going out of the sensor port \

[@sw1yper]

hi Mr Mel, does this application same as the hobbywing sensor? thanks much lemuel

[@alim1891]

hi friend,why can I not found you other video about kontronik jive programing and by the way you are the best.

[@FredrikMelin72]

With a Kontronik 80HV you cannot run the VBar governor, stay in Mode 4.

[@FredrikMelin72]

You cant, you HAVE to have SBus or Spektrum Satellite setup, you cannot use separate receiver setup, then you need fullsize vbar.

[@itsusatst20]

thank u for fastest reply ever :)