thank you very much it takes a woman to show the correct way of doing it your a legend
@kathytukavkin2522 Жыл бұрын
Oh man I'm glad I found this video to let me know about the manifold gaskets before I went too far. Thank you for posting this, it's extremely useful mate 👍
@kokodeshine000 Жыл бұрын
That connector at the back was stressing me out lol got it done though. Thanks mate.
@Takster20 күн бұрын
Great vid mate straight to the point 👍
@aresiusm621 Жыл бұрын
Thanks for the video. A little disappointed you didn’t show replacing the gasket though. Some people say to use RTV for the gasket but it has a rubber seal so I guess as long as the surface is clean it should be fine. Replacing my sparkies and ignition coils as I have a misfire on 3. Thought as I’m taking the plenum off and don’t want to again it’s best to replace all coils not just the defective one lol.
@johnnys27148 ай бұрын
Really well explained, terrific video, thankyou
@Luckyboy-bj5pq11 ай бұрын
Thanks mate, lucky I had the gasket. They always rip. Much appreciated friend
@leev1498 Жыл бұрын
Very informative. Great vid. Thanks mate.
@trevorquinnell85152 ай бұрын
sux you actually have to take manifold off to this i think we need some1 ro design manifold that is better access for the plugs
@andrewwestover72782 ай бұрын
They did on the later models. I just changed the plugs on my 2010 VE SV6, easy job, no need to touch the manifold, took about 30 minutes.
@abdaonalmasaoudi3591 Жыл бұрын
Thanks
@kulibo111 ай бұрын
What happened to manifold gasket?
@Will-nb8qk Жыл бұрын
I tried to lift up manifold after taking out bolts of my 2006 rodeo but seems stuck in solid. Any thoughts?
@Will-nb8qk11 ай бұрын
@@DeeDee-uw7gu : I just levered it a bit and realised they’d used gasket glue prior. 🤷♂️
@Will-nb8qk11 ай бұрын
@@DeeDee-uw7gu probably a tap upwards with a rubber mallet would do it. I think I just used a wheel spanner to lever it up. Once you crack that glue in one little spot it’s good to go.