Vevor UB-100 Metal Bender Problems (Part 1)

[@muskokamike127]

Good points, one thing about the line on the base: that could be the casting parting line where the two halves of the mold came together. As for the edge of the locked in form, you might be better to true up the base instead of the bend edge. For the sharp 90 deg bends if you remove too much material there, you'll start to get a radius in your bend (or a larger radius than you like). I'm not surprised you have to "tune up" a cheap chinese piece of equipment. That's pretty much a given when you buy something cheap from china lol. One thing about the locked in form not being centered on the pivot: is it supposed to? The reason I ask is because almost all the other benders I've looked at, the bending part that actually does the bending isn't centered either. Anyway, good luck!

[@tommym936]

Just struck these problems with my new one as well

[@DivineMisterAdVentures]

You got 1 comment. Did you ever figure this out?