Video Tutorial: How to make a Bike Frame with Fusion 360 in just 10 minutes.

www.enricodellavolpe.co.uk
/ enricodellavolpe
/ enricodellavolpetechno...
/ enricodellavolpe
www.tiktok.com...

[@seannibecker5500]

How many times did you practice that before you shot the video? Very impressive.

[@pedro-neves]

Thanks!

[@vishalroy5486]

you just rocked bro..🔥

[@owenfidler2115]

Finally, a video tutorial I don't have to run at 2x speed! Thank you!

[@LeviKerrison]

Legend 👌🏼

[@EnricoDellaVolpeTechnology]

Thank you so much 🙏

[@ismaillamraichghailan2116]

nice video henry, i really learnt so mucho from it

[@EnricoDellaVolpeTechnology]

Thank you so much Ismail

[@LearnThatTheme]

Pro tip - click the 3D sketch 1st before you start sketching, otherwise you will lose constraints. You can see many lines are blue and not black, meaning - not fully constraint. Good tutorial nevertheless.

[@EnricoDellaVolpeTechnology]

Thank you for you comment. Yes you are right you should add contraints to the blue lines

[@LearnThatTheme]

@@EnricoDellaVolpeTechnology I just realised, even if you start the sketch with 3D it still looses the constraints. The only way to do it is to apply more sketches on supplementary planes to have "everything black" / fully constrained. Fusion 360 is bad at for containing all the 3D sketch lines in a single sketch, unfortunately.

[@skumancer]

Grazie Enrico!

[@EnricoDellaVolpeTechnology]

Thank you Ricardo

[@МаксимБалахонов-к7ж]

Буду пытаться повторить ! только нужна рама для электровелосипеда с двойной верхней и нижней трубой

[@christopherwilson6527]

Ten minutes you made a full bike frame. I spend an hour making a box 😂. Its fun to learn

[@EnricoDellaVolpeTechnology]

Thank you so much 🙏

[@ritesh1797]

i need to slow down your speed teching