RAUDI Mid-engine Audi 20v Powered Rover Metro Project - EP10

In this episode I finish the rear subframe mounting and make more progress on the roll cage, fabricating the cross bracing in the main hoop and installing the dash bard and steering column mounts
Tools:
DeWalt Drill Bit Set: amzn.to/2WPi9CQ
Non-woven Abrasive Disc: amzn.to/2W77mHa
/ visionautogarage
/ visionautogarage

[@SkylarkCamperAdventures]

Perfect timing, just needed something to watch after waking early! Good progress being made 👍🏻

[@VisionAutoGarage]

+Skylark Camper hopefully it didn’t make you fall back to sleep! 😂

[@SkylarkCamperAdventures]

Vision Auto Garage Nah, always interesting to watch.

[@PedalBox]

I wondered why the stalks looked so low, but I haven't been in a Metro for a decade or more so didn't question it! Recently got a set of those dollies and have to say, I wish I'd bought some a few years ago. Cage looks super, need one in my Golf at some point (fire allowing...)

[@VisionAutoGarage]

The dollies are great, I have two sets of 4, eBay wins!

[@paulandrews3785]

😍 👍 looking nice geting there

[@brookfab_5188]

Non woven pads are awesome. You're welcome. Lol.

[@VisionAutoGarage]

You're my hero!

[@MrRuairidhw]

You could do with looking into drill speeds as every drill bit has an optimum cutting speed. Might hely you're drill bits last longer

[@asp102]

Looking so good. With it being read wheel drive and the engine in the back, is there going to be enough weight over the front wheels to actually steer? :P

[@croonersteve]

youre runner the drill to fast at that size hence why you are wrecking your bits, slow it down as you increase drill bit size, 6mm or so would be good at that speed not much bigger

[@VisionAutoGarage]

+croonersteve possibly, its 480 on the DRO, so not that fast.

[@paullaurance3282]

That FUCKIN music. Aaaaaaaaaaaaaarrrr.

[@ryanhepton5847]

End of video the last tune what's it called?

[@neilmchardy9061]

You have two resilient mounts and two solid won’t something crack?

[@Anderzander]

neil mchardy dropping the old style landrover engine mounts in there might be an easy solution. They are pretty compact.

[@Anderzander]

Any reason you switched to mig for the cage and mounts this time?

[@VisionAutoGarage]

+Anderzander yep! Speed, cost and ease. I’m too old and fat to contort myself enough to use the pedal inside the car 😂