VLM carpet cleaning in office building - Did I turn a 175 into a Orbiter

[@squeakandbubblescarpetcleaners]

Great job. You need to lift the handle on the rotary higher. You'll end up with a bad back. Wants to be about waist high, not thigh area. Back needs to be up right. But if that works for you. Great job once again.

[@jscott4613]

I'm glad you showed the correct way..carpet brush then bonnet..slot just use bonnet ..not the same👍

[@anelmarkovic1043]

Is that brush soft or hard bristles? Great job!

[@MichaelCampos-f6q]

@GreenRhinoProject - May I know if you still do extraction using the wand after using the polisher/175? Or not anymore? Thanks.

[@jeffbaker9595]

Looks great! I dig your videos man ✌🏽

[@kodakid59]

Nice Job! That system rocks on glued down olefin!

[@mindful__gardener]

If there are stairs does that help you decide on using water extraction instead of big rotary 175? Seems to me that using the big 175 would be good for commercial same level floor or elevator use. For residential I could also use smaller oreck for vlm. Mix and match my tools to get easiest way to move gear and do the job.

[@KPCC]

I don’t have a truck mount I have portable. Can I still use a online pump sprayer

[@BlockchainToTheFace]

Battery powered sprayer is WAY more efficient

[@pughsprofessionalcarpetcle8415]

Outstanding buddy as usual....

[@greenrhinoproject]

Thank you !

[@makelifepay7612]

Great work

[@kalyawam]

Your buffer is wobbly because it's not contacting the floor squarely, either raise or lower your hand levers

[@SkidMarkSmeller]

Do you mind me asking what you charge per square foot for vlm cleaning?

[@baltimorebigman5999]

Great job looks really good may I ask what chemicals you recommend for the job pre-treat and also Chemical for the pad?

[@KPCC]

Good evening Sir what is the name of that brush and do I get it from

[@brucemiller5343]

If i put a smaller pad on a faster buffer and made it off center like you did would it be safe for the carpet

[@macekpavon9006]

Now im confused. Everyone says black brush and striped microfiber are for hard surfaces! But you literally proved otherwise! 😮

[@terencebooker557]

What kind of bonnet are you using?

[@mr.kleanentertainment8898]

Pure Genius on offsetting the brush for orbital motion 👍🏾👍🏾

[@whoooozen]

That isn't orbital motion. The driver would actually have to do small orbits at 10 times the speed.

[@forwhatitsworth364]

6000 ways to make beer money with a 175. The best tool in the shed if you ask me.

[@wallacetillman584]

what brand and size floor machine is that? I'm not sure if I should get a 17 inch or 20 inch model.

[@greenrhinoproject]

Tripple S. 17 inch is best for most jobs.

[@mindful__gardener]

What size bonnet is that for the 17 inch ?

[@greenrhinoproject]

17

[@tomd720]

you should try the blue and grey microfiber scrub pads , they absorb more soil .

[@forwhatitsworth364]

I just purchased one.

[@tribeofbenjamin6]

Do you have a link?

[@LoveeJm]

I have a question hopefully you can answer. Can I do this method but using the oreck orbiter to agitate and then use a bonnet on the oreck orbiter to pick up the soil? And if so can I also do it with tile ?

[@GarbageBarge]

Yes and Yes - It will do just as good as the 175 but it will take longer.

[@fifeange5919]

After you prespray and agitate is it best to go over with the bonnet? Or do dwell time then bonnet?

[@greenrhinoproject]

depends on your solutions Do recommended dwell times

[@joemayo4354]

What's up with the chipmunk voice🤣🤣🤣🤣

[@rugratscleaningsolutions1179]

With low moisture cleaning is it still required to agitate prior to extracting with a pad? Even when using pads such as iron man

[@greenrhinoproject]

Yes for best results unless carpet is considered light cleaning. Always good to agitate dark areas before extraction.

[@icleangrout]

what Pre spray did you use?

[@greenrhinoproject]

Carpet details

[@knockoutdustbusterscleanin1969]

Great job once again! Would encapsulation be more costly than wet carpet cleaning? Thanks

[@Lilmiket1000]

No. Extraction is top tier.

[@Cynthia-qo9wu]

👌🏻💯very satisfying ☺️

[@greenrhinoproject]

Thank you 😋

[@santosmembreno2001]

You have to put a little more solution!!

[@Lilmiket1000]

Lmao good try. eYah putting the pad on off set doesn't make it an orbiter. Probably helps agitation but real orbiters make 1700 revolutions per min and usually has a pounding action to it as well.

[@focisdfo0deuce]

Im an avid follower and i tune in daily to view your outstanding content!! Keep it up! I have a question, I use an oreck orbiter. Do you prefer the 175 over the oreck due to the wobble of the oreck? @Green Rhino

[@greenrhinoproject]

I like both tools and use oreck very often mostly for stairs small areas and pre-scrubbing but i like the size and the weight of a 175. the weight seems to pick up more in my opinion but there are some who would probably disagree. Also its bigger so you can clean faster. The one i have was only $700 brand new. I a person that wanted to go VLM had both tools they would be able to clean almost every area in a home.

[@focisdfo0deuce]

@@greenrhinoproject thanks for the insight!!!

[@dewaynemarcionette6112]

I find that the Bonnet cleaning works better on that low pile commercial glue down because with steam cleaning often times you get a wic back and as the carpet dries it a suck up anything that's in the concrete floor and often your stains will come

[@richardmartinez2973]

Why doesn't anyone use a dirt napper brush. You can brush and pad at same time

[@saulpaul7263]

@@richardmartinez2973 where do you get that?

[@vincentswerkes8637]

You are very wrong about off set pad being a orbeter .

[@theegarbageman8056]

what speed if too fast for agitation and bonneting?

[@greenrhinoproject]

175 rpm and under is fine.

[@theegarbageman8056]

@@greenrhinoproject so 200 is bad i have a 200?

[@greenrhinoproject]

@@theegarbageman8056 That should be ok

[@corey4623]

Hey man I would love to talk to you il pay yea

[@greenrhinoproject]

tinyurl.com/bdfxayxc

[@eugenioaragon5238]

No se te entiendo lo que hablas

[@maxaugustin4179]

too much walking its called a swing machine for a reason

[@greenrhinoproject]

So you think you can clean all the carpet without walking. Come on don’t be petty