Volkswagen Scirocco - Rear Door Card and Speaker upgrade Part 2

Hey guys it's FL4ME WITH A 4 with yet another helpful video, and this time i am going to show you in part 2 on How to remove the Drivers side rear Door card.
Here is what you will need.
Tools required :
1x T25 STAR TOOL. AND T20 STAR TOOL
DRILL WITH METAL DRILL PIECE, TO DRILL OUT RIVETS.
PHILIPS END SCREW DRIVER.
SMALL FLAT END SCREW DRIVER.
TRIM TOOLS
1X STRENGTH..
----------------------------------------------------
YOU CAN ALSO FIND ME ON ……
[e-mail]
FACE BOOK - FL4MEWITHA4 : / fl4mewitha4
TWITTER : / fl4mewitha4
FACE BOOK: / gtrskyline01
INSTAGRAM : / fl4me84
SNAP CHAT : flame1984
VINE : FL4ME or @flamegtr

[@terjehen1980]

The negative wire is the blue one and the positive is the Brown One. Just follow the two wires from the woofer connector(connector with 4wires) If you look back at the tweeter and follow the Plug you notice on the back of the tweeter there is a crossover built into the tweeter and the side that the capasitor is soldered to the terminal is the positive. So that means your car is different than mine in what you said was positive and negative in your Video. Even easier methid is to check color on wire that goes to the positive terminal from the woofer connector.

[@jamesparkinson72]

Thanks Mate, managed to do my fronts this week with the help of your video. I bought a Active sub for the boot and am looking for instructions to run the wires. I am going to loose the rears and use the 2 channel low level converter to provide the audio.

[@sholtodepuma]

Watched a few of your vids while fitting my sub in my scirocco this afternoon, really helped a lot you're a legend. Getting those rear door cards back on is a right pain. I still don't think mine are on properly. The worse part is the peice of trim at the highest point in the rear corner above and behind the window.. Cannot get it back on tight for the life of me

[@kabbi3161]

Hi there, why do you have to take that off do you have to splice into the speakers or something?

[@simonerossi9652]

Thank you! I've ceiling tissue unglued and with your videos finally i got down it...maybe i'll upgrade speakers too in the while 😁

[@FL4MEWITHA4]

Anytime and thanks for watching 🔥

[@SPEEDDRV]

Great explanation mate! Great job. :) Well done my friend! Tell me please, is it really necessary to remove the plastics on the boot to put back in door cards? Also, I have a rattle on the plastic behind driver side, pilar B, where the seatbelt is. Do you have any idea how to remove it? There might be something loose inside it. Thanks for the video once again! :)

[@FL4MEWITHA4]

The Centre pillar B is only held on by clips, so trim tools will remove them with ease :) also YES it is so much easier removing the rear boot trims and it lines up without complications, i had to do it for the drivers side as well, but it only takes 5 mins to remove and put back, so an extra 10 minutes each side, i hope this video helps you in your installation :) Thanks for watching and feel free to share..

[@mikebusse7005]

what size is the speaker?

[@memoonahassan1520]

Excellent thank you so much

[@jackdraper9363]

hello dude, where can i find the cabe adapters?

[@FL4MEWITHA4]

Jack Draper here is a link 👍🏻😁- m.ebay.co.uk/itm/VW-Golf-Mk4-IV-99-04-Speaker-Adaptor-Plug-Leads-Cable-Connectors-Pair-PC2-807-/151114887575?hash=item232f263197%3Ag%3ADukAAOSwmLlX4SsC&_trkparms=pageci%253A15fd6b42-170e-11e7-ad23-74dbd180bf38%257Cparentrq%253A2ae7e57415b0a2a4f8632991ffff1956%257Ciid%253A2

[@shaungcuts]

Thanks 👍🏾👍🏾

[@FL4MEWITHA4]

S.Campbell 👍🏻

[@predatorlooping3]

Hi ... thanks for this vidéo ... i have a question... WhatsApp is the type and the brand of the tap you use for thé phonic isolation .... thanks for your answer