VY ute rear bearing and bush replacement part 6 handbrake and axle install

[@melissakern9030]

I have embarked on this idiotic journey of replacing and rebuilding the entire rear end on my Ute and I just wanted to say how much these videos have greatly helped me. Your channel is my go to bible for most of the work I have done on my Ute. I would’ve loved to see how you did your axles as it’s always been a job I’ve been unsure about

[@mwoods2062]

Thank-you very much for your kind words, it gives me the incentive to keep making these videos. Yes the axles are a pain but I just used some heat and a brass drift but still a lot of work. You could try a big slide hammer with an attachment that bolts to the wheel studs.

[@paulbruh7683]

Good stuff mate

[@mwoods2062]

Thanks mate