W124 Replacing Front Wheel Bearing

[@lucientsehla1434]

Very clear instructions and excellent demonstration. Hats off 📴

[@FriendlyMBTech]

Thank you!

[@iamhapidays8766]

Great tutorial neighbor!

[@FriendlyMBTech]

Thank you!

[@usernamefromhell]

A bicycle headset press is cheap and will get those races in straight

[@waelmr4822]

What about the back wheel bearing?

[@FriendlyMBTech]

I haven't had to do that one yet. When I do, you can be sure I'll do a video on it.

[@waelmr4822]

@@FriendlyMBTech it's very difficult and you should have a good tools and open more parts like the driveshaft and the egsost

[@FriendlyMBTech]

@@waelmr4822 I do need to replace the center support bearing on the driveshaft, which I have been putting off.

[@waelmr4822]

@@FriendlyMBTech my respect to you from iraq

[@Visionery1]

MBs fantastic W124 engineering once again comes to light. Do current MBs share this retainer design?

[@FriendlyMBTech]

No they don't. The new vehicle have sealed bearings hubs that bolt on.

[@MMWA-DAVE]

Have you ever had to re-adjust the bearings after setting them as per the MB method? I did this on my w124 exactly as per the book and they ended up with too much play after only a few test drives and had to adjust them using the old fashioned way- tight up the whole way till cant turn then back off slightly.

[@FriendlyMBTech]

I've never had any complaints after doing them so I really couldn't tell you. If I can't find the dial indicator because it's in use, I'll do it your way, it gets it really close.

[@privateparty4900]

Have you seen enough of the newer cars to suggest W212 or W213 from a reliability standpoint? E350 vs. E400

[@FriendlyMBTech]

I'd personally choose the W212 E350 over the E400. Especially the later years of the W212 with the M272 after they ironed out the issues. So no balance shaft issues.

[@hershhiljr4076]

Hey I was trying to reach out 2 u on Benzworld about an issue about a ML320 ( e320 4 Hersh)

[@FriendlyMBTech]

I sent you a message on BenzWorld.

[@bernardgelderblom8818]

I hate pressing those bearings out , messed up a couple in my life , hehe

[@FriendlyMBTech]

I just pound them out with a punch.