W222 Mercedes S Class Front Pads and Rotors Replacement

[@CarsYouCanFix]

Long Handle 1/2" Drive Ratchet : amzn.to/3LS55sa

[@Lilb33z]

You have the best video on the w222 break job

[@CarsYouCanFix]

Thank you! That really means a lot!!

[@erico5512]

Great video, thank you very much very useful

[@CarsYouCanFix]

Thanks for watching!

[@kwickstr]

Great video. Very helpful. Earned a new subscriber 💪🏻 thank you

[@CarsYouCanFix]

Thanks for supporting my channel!

[@misu110382]

Great job !

[@CarsYouCanFix]

Thank you!!

[@miltonpenaloza]

Great Video! My 2018 Mercedes S-class needs breaks and rotors. How much did OEM parts cost?

[@CarsYouCanFix]

Thanks! I found these rotors online for about $200 each. Wasn't able to find a quality aftermarket rotor so we just went with OEM. Thanks for watching and subscribing!!

[@waterzap99]

I just bought oem rotors and pads for the front end. It was around $1000 at the dealer. You can get it cheaper online but then they will charge a lot of shipping. The rotors are super heavy. Prob 40 lbs each.

[@bigfacts1592]

Oh I can do that, thanks a lot😎

[@CarsYouCanFix]

No problem! 👍

[@vraniskpashku2551]

How to pump brakes after change brake pads without turning on the abs

[@CarsYouCanFix]

Pump the brakes before turning on the car, I've had some older mercedes throw an abs light but after driving a bit and turning the car on and off a few times, the abs light went out.

[@vraniskpashku2551]

@@CarsYouCanFix so i did with mercedes w211 e270 2008 After i replaced brake pads Abs turn on I turn on of 2 times and abs light go off .Sorry if I disturb you but can be another way not getting problems

[@vraniskpashku2551]

@@CarsYouCanFix where is lokate fuse box and can work with all cars and models wich have suspension air

[@CarsYouCanFix]

@@vraniskpashku2551 You would have to look up your specific model to find the fuse box, but the one in the engine bay usually will have the suspension fuse.

[@CarsYouCanFix]

@@vraniskpashku2551 OK So I personally haven't done this before, but certain ABS modules you can disconnect the big connector on the module during the brake replacement. And that should prevent the ABS lights. There may be a specific procedure to do this correctly but I've always opted for just turning the ignition on and off a few times to clear it.

[@vraniskpashku2551]

How can jack up a car with air suspension becuse when i jack up a car the entire car goes down ?

[@CarsYouCanFix]

On vehicles with air suspension I pull the air suspension fuse to stop that from happening.

[@raphaelkalina653]

“That’s what she said”