Walbro rebuild-Part 2 of 3 Water logged Poulan260 Pro

Part 2 of 3 of the "Water logged Poulan" Cleaning the Walbro WT-391 Carb. The carburetor is surprisingly clean for the amount of water and slime found in this chainsaw. ! Any information ,advice ,or corrections, are always welcomed in these videos. They are to help the "do it yourselfer" so please always feel free to comment and make corrections.

[@805ROADKING]

Great video Tom!! You do a great job explaining the process and excellent well lit close up shots!!☺

[@beaniebrooks2077]

Good video. I am reviewing it again as I may have a gasket wrong as I cant pull fuel thru carburetor with primer bulb & I know it's good.

[@MrDanoconnor]

Very Well Done Tom.....You got a lot more patience than me Buddy, .I have only about a 50% success ratio messin' with those small carbs. You obviousl;y have lots more experience & confidence than Me with the small stuff. I have no doubt you'll have that old saw back togeather & screamin' in no time.

[@victorotwell9325]

good video I realized j had put the bottom gasket on wrong saw runs great now

[@paulgettinger6174]

I know this an old video, but is very good. Before installing carb to chain saw I could not pull fuel threw carburetor. Does it need to be installed to get the vacuum impulses from engine?,.

[@vboss5764]

Does the metering diaphragm go next to the block or does the gasket go next to the block then the diaphragm?I've watched several videos and I've seen it both ways.

[@audiocage1]

Hey, thanks for the video that was really great. Although I do have some questions for you. I had seen a video that someone else had done much like yours on rebuilding the carburetor. The part you called a welsh pin and that assembly is what I have questions about. In their video, that adjustment screw was set to a certain amount,not fully tightened. Is that true?

[@500passwords]

nice informative video man . are the stihl saw carbs similar to this ? thumbs up buddy