Wallaroo Mac Baofeng Mic Enhancement

[@n1kkri]

Need to repeat with same radio for both mics. Also, would have been nice to been able to listen to the mic audio

[@eugengrzondziel1706]

i am missing the audio records of both microphones to compare the quality

[@bluesaloon22]

I did a very similar mod to you but used sticky backed draft excluder foam to creat a gasket round the mic element. I covered that whole side of the board with foam and also the inside of the back cover to fill all the acoustic voids. The enclosure doesn't resonate as much so the receive audio is clearer. Even the button click sounds more satisfying now. .

[@ricsanders69]

Should have kept the same radio with the two different mics...for a true test!!

[@JoeyMontana151]

Modification worked perfectly with me, at least 85% better. Did exactly how you suggested, only thing was I used the tip of a soldering iron gun to melt the tiny hole.

[@johnwuest1412]

Great video. Not only informative, but entertaining as well. Thanks, Mac.

[@georgthrx]

i did exactly as you and the result is great.....the mic gain has improved 1000% !!!. THANKS !!

[@dalewykoff7058]

Modification worked great. Local hams could really tell the difference over the 2 meter repeater. TNX.

[@alapon77]

Thanks for sharing. Very helpful! Would you happen to have any suggestions on how to make the connection of the microphone plug into the radio more 'conductive'?

[@californiakayaker]

This is how you would do what is necessary if you had littlerally no tools . First get some tools. A pair of nippers , $3 , usually red , originally were sold as clippers of leads off pc boards. A small soldering iron. A little epoxy or superglue. Don't bother making the hole larger, not necessary. Remove the microphone from the board with your soldering iron. Add a couple insulated leads to the pins. not too long, long enough so when you glue the microphone directly against the hole, you can put the leads in the pc board holes and solder them. You could fill the hole where the microphone is with foam, although you would do it for mechanical stability. The microphone is against the hole now, it will sound great. It will sound better than this mod because you glued it right to the little hole. no gap. That's how its done.

[@Fitzach12]

"go ahead OMG" 😂😂 Great video

[@stephenwilliams5201]

Tks om. Got 4 ordered. Get dragons better sound and the high rollers away from me head tks kv4li

[@bushpig59]

OMG!!!!

[@B.Murphy]

OMG Carl!

[@MikeG-js1jt]

Although it does the job, that is the strangest most miserable of screwdrivers I have ever seen, seems like something that was crafted in the jungles of Borneo by natives that have never even laid eyes on a bicycle.