We put together the Langmuir Systems Crossfire XR CNC Plasma, first cuts. what a disaster.

[@patakiattila8970]

Just a quick question guys, would you pay 10.000 USD for a similar table BUT with 1500W fiber laser? Cuts till half inch mild steel. We plan to manufacture in large quantity that is why asking

[@FoothillsAdventures]

Yeah definitely

[@jacobherrera3598]

What different software wares did you have to download in order for you to cut what you want

[@FoothillsAdventures]

@@jacobherrera3598 just fusion 360 for designing and getting the cut file ready. And then you need langmuirs software to cut it.

[@GeneralChangFromDanang]

I'm starting to wonder if they just shipped me a basket case. Did you have any problems with the water table being warped and the slats not sitting right? I have as much as a quarter inch height difference from slat to slat.

[@FoothillsAdventures]

One of our center sections kind of bows upward and presses against the bottom of one of the slats. Luckily with the weight of all the slats and water it sits down. The was a pretty noticable difference in the edges of the of the panels. We just held the two edges together when we bolted them. The biggest thing I think that helped was bolting the water table together before screwing it down.

[@GeneralChangFromDanang]

@@FoothillsAdventures Yeah, I didn't think about the weight of the water. We finally got it up and running this weekend and the slats seemed to have flattened out quite a bit. At least good enough for a plasma table. Overall, I'm very happy with it as long as the electronics last.

[@FoothillsAdventures]

@@GeneralChangFromDanang We have been cutting things like crazy here, just about anything we can. We are burning through consumable pretty quick and i just placed the order for my third set of consumables. I am glad you got it up and running.

[@bulldog_7577]

What size torch do you have on your machine and is there any lead left over or is it at limited capacity?

[@FoothillsAdventures]

@@bulldog_7577 we're using the razor cut 45. We run it at 70 ipm at 32 amps and the dross isn't too bad

[@samuelgonnelli4367]

Im looking to purchase this model. Would you say your happy with langmuir so far?

[@FoothillsAdventures]

extremely happy, We have had only one issue with the motion control board, and Langmuir covered it under their warranty. It was a learning curve for the software especially for me.

[@chuckster6513]

Your volume control needs some attention ! Your speaking required me to turn up all my volume controls to max to barely hear you, Then the music about blew out my speakers.

[@FoothillsAdventures]

I completely agree. I am sorry about that. I have had my hand at some automatic levelling but the automatic levelling only works per clip. I will take a good look at it before posting. Thank you for watching .

[@Lego31866]

Before posting something that could be construed as negative, PLEASE contact the mfg. If they ignore the consumer ($$ u and me) then, ITS ON! 👍🥳