WeatherTech Side Window Deflectors Installation and Review

Quick video of the unboxing and install of the WeatherTech Side Window Deflectors on the 2017 Honda CR-V Touring

[@spoofer76]

To anyone that watches this video looking for how to install these damn clips....the clips go inside the weather stripping. In the channel of the weather stripping there is a flap that folds down(most videos/weathertech shows the flap lifting up), its on the side toward the inside of the car. The flat square part of the clip goes in and down into that flap and the angled part will be out toward the outside of the car. Hope this helps someone!

[@xenli]

This was very helpful. Glad I saw your comment.

[@nmtscrub]

You should really show the entire process for the rear. The clips are not eaay to work around for most people who get this for the first time. If anyone can do better, please show the critical steps so nothing breaks. Thank you

[@Cichlid-Fever]

i didnt use the clips and they have been fine for a year

[@killervampir]

Note to self when making a video install video show the install not a slip of it in ur hand ans the next on the car. U should show how to deal with the clips

[@madblackman365]

Exactly

[@N9olan]

He most likely didn’t have anyone at the time to hold the camera for him nor a tripod…

[@bryanmchugh1307]

I have these for my 2018 CRV. My kit did not come with clips. So the deflectors are supposed to go into the window channel right? Mine wont stay put. After the window has gone up and down they will pop out of the channel. Gonna try it again. My rear window deflectors did not have any adhesive on them.

[@larrywilson7933]

You don’t really show putting it in. You put one end in, then the other end and showed finished. Not very complete.

[@Redd_dredd]

Nice video . Can you tell me if the weather tech logo on the side is removable or it's a permanent stamp?

[@OGpuppetAlief]

It is removable...it's easy to remove

[@madblackman365]

Terrible you left out the hardest part

[@olgaguer6443]

Thank you!!

[@MimiMimi-yt6mp]

You don’t physically show how you do it. Why?

[@isaiahdarnes3621]

Did you have any issues with rolling the window up, mine touch the deflector everytime I roll up.. and I'm pulled outward on them quite a bit

[@fleadoggreen9062]

There is another video on here where you make sure you make sure you have the visor rest on top of the base of the Chanel, I’m not explaining it good it’s in the youtube video

[@kriskabin]

Yes, after a year my windows, especially the front door windows, sence an obstruction & will stop & go down automatically. I have to do little presses on the window button, not a continuous press, to get my windows completely up.

[@TheBLKCrows]

Yuk. I hate how the back one bows out like that. On my ride to. Am About to put 3m take and take the clips off

[@nsiebenmor]

Do these offer good sun protection?

[@soniadiaz9590]

I have a 2019 , and I’m having a problem with the front windows , when I roll the passenger window up it goes back down .

[@gusthomas]

That also happened to me with my 2020 Ranger. My fix was to hold the window button up until it gets to the top and hold it there for 10 seconds, then push the button down and when it reaches the bottom hold it for 10 seconds again. Then let the window go up on auto and it should stay up. Your vehicle may be a little different, but if it is I bet the dealer could give you the hack to over-ride it.

[@dannycrockett4833]

Dident show enough of clip install….lame

[@crodrig411]

Get the outside adhesive much better,bought inside model troubles with windows closing,destroyed my windows seals

[@dawni.ferris4147]

Why do you not ACTUALLY show what you’re doing? For instance, you say you’ll fit the guard in place from front to back, but then the video skips ahead to the point at which you’re done. You do this several times. Annoying.

[@tigner1]

This is not a good install video; there is one that shows that you need to rest the visor on the channel top! VERY IMPORTANT!!!