Weber 32/36 Carburetor Rebuild

[@6thGearGarage]

Very helpful! I’m about to tear into my Weber for the first time and now I know what to expect.

[@peterlobb6456]

Good video, given me the confidence to tackle my carb rebuild this weekend. Thank you!

[@outdoortypelifestyle9489]

Glad it helped! Once I started to dig into it, it wasn’t that bad.

[@ronarndt6722]

Don't forget to re-calibrate the float assembly 🙂

[@joshslocumb7936]

So cool .. great How too info

[@outdoortypelifestyle9489]

Thanks!

[@gregoryschwarz2730]

Gotta do this on my 72 VW Bus, thank you!

[@outdoortypelifestyle9489]

Glad you found it helpful!

[@victoralcantara2767]

thanks for the video... my carburetor works well my problem is that a lot of gasoline passes into my intake, I realized because when I removed it there was a lot of gasoline at the bottom of my intake... I hope you can guide me in a bit. thanks

[@outdoortypelifestyle9489]

It might be that you are running rich. There is a screw to adjust this ratio on the side of the carb. It is different than the idle set screw. Get the vehicle up to temp. Start turning the air/fuel screw clockwise. When you hear the engine want to stall, back out the screw 7 turns. That was the right number for the 4.2L of mine. If it’s a different engine then you’ll have to find the middle of stalling lean and stalling rich. I hope this helps a little.

[@victoralcantara2767]

@@outdoortypelifestyle9489 thank you 👍

[@Tricky_Ricky15]

Thank you @14:00

[@outdoortypelifestyle9489]

Yeah, magnetic nail finders are my friend!

[@leshalliday2015]

Could you please point out all the adjustment screws please especially the mixture screw.thank you.

[@outdoortypelifestyle9489]

Yeah, I’ll try to pull together a video to adjust the carb on the Jeep. The Weber I have only has two. One is for the idle circuit fuel/air and one for the idle speed.

[@mikefriesen19]

Great video thanks

[@outdoortypelifestyle9489]

Glad you liked it and thanks for watching

[@ThomasWright-f1x]

Brought a new carb leaking water out of choke asm it's missing gasket I see the round gasket sitting on your table interesting

[@Bimmer_Bob]

You didn't check the float level?

[@goodllookin1722]

Why didn’t you blow anything out, what the point in the kit

[@warkal868]

What is the jet sizes you're using?

[@outdoortypelifestyle9489]

I think it’s just stock. That would be 150 main and 50 idle. It was already installed on the Jeep, so I don’t know for sure.

[@goodllookin1722]

Mickey mouse

[@ryanadkins3076]

You should absolutely be spraying carb cleaner through all of the passages and jets. None of the stuff you did in this video will fix the issue you described.

[@goodllookin1722]

I agree

[@goodllookin1722]

He not doing anything correct