Weed Eater Starter Housing Fix

[@lancejones6420]

Good job in explaining the process and the right parts ! Thanks..

[@turdferguson3669]

This was very helpful as both pawls on my unit were broken and I had no idea how to install them.

[@huntersworkshop7999]

Glad it helped and if you ever have any questions on small engines for lawn or powersports just ask on here and i will try to answer your question to the best of my ability.

[@davidkirschbaum4300]

Great video, worked perfect. Just add that I had to carefully tap out old pins on mine ! Thank You

[@charlesgraves8560]

me too

[@threejackcity4471]

Nice video. I think I pulled too agressively and broke off the little holder tabs because suddenly, the starter would just spin when there had been no issue before. Problem was that when I took it apart, both holder tabs were cleanly broken off and I didn't realize the pawls were missing the tabs. I saw some pics and began to wonder and then your video confirmed it. I had the idea of fixing with little screws but wasn't sure it would work until your video confirmed that it would so now the starter assembly is working properly. Thanks!

[@huntersworkshop7999]

I have willingly cut them off drilled and put steel pins in to replace the tabs because some older models break a lot because of heavier pressure release valves on startup

[@rogercamp6071]

Your video helped greatly, I'm working on a similar Craftsman trimmer with the same problem, now I know how it goes together Thanx😅

[@philliphall5198]

Great job and Thank You for information and advice

[@randypeck5797]

Good information. It helped me figure out what’s was wrong with my paws

[@a.j.williams195]

It's pawls stupid

[@al52269]

Great video. Thanks for sharing. New subscriber here