When you use a short intake manifold on a CT200U-EX

[@billweston1655]

@Black66 Are you able to find a bigger intake manafold and see the difference between the two you have now.

[@Black66]

I have used an even longer intake in this video...kzbin.info/www/bejne/bpvUq6Z-bK2dgpo

[@Minibike817]

Gopowersports needs to have you on their podcast series!!

[@darrellnichter9894]

@gopowersports...are you paying attention! I've said the same thing many times!

[@Deucealive75]

Your 0-30 and throttle control are impressive. Quick bike.

[@dmann1209]

Excellent experiment. I often wonder would a higher horse power engine make a difference with those clutches and torque converters? I have say it is always a pleasure watching your content. Fun and educational.

[@Black66]

Thanks! I have some videos on the playlist with torque converters. Im working on a new one now that will be out soon. kzbin.info/www/bejne/jmG2nnSQf5ukjZo

[@srcobra50]

I like the short Intake for the way it’s installed. Easier. The loss isn’t too big of a difference or important for my kind of use. Might invest in one soon. Cool video

[@Black66]

Thanks, yes I mentioned that at the end of the video. It doesn't make much of a noticeable difference on the bike.

[@PaulLuffman]

I built a tillison engine, I forgot I put it on a trailmaster storm. The motor mount plate was too thin and it ripped to chunks out of the plate where the front bolts went. It took six months before I found a Coleman ct200uex without the motor. I left the original tires on it but a 10 tooth clutch and50 tooth rear sprocket smoked the clutch . These tires are 19 in in height. If I go would get a17 are a little smaller I could probably put my 50 tooth rear back on . I have a 60 on the rear sprocket right now

[@Black66]

Check out the CT200U-EX playlist for many clutch and sprocket combos on this bike. kzbin.info/www/bejne/jmG2nnSQf5ukjZo

[@PaulLuffman]

@@Black66 thank you.

[@SpACeCruizeR2o3]

Thanks for the test man that's not bad compared to like a stock from for a third of the cost not even💥💥💥💥

[@mike-ws4hl]

I think there is something some people didn't think of ?¿? Timing is going to need to be changed for the best results plus what fuel is being used ???? A person should have access to a dyno for the best performance!! I liked what you did !+! I would love to be able to do half of what you are doing !!! I'm working on a few things 2 go carts in pieces when i got them !+! I'm running out of time i will be 59 in a few month's LOL !!! Seriously i just recently bought a new massio mb 200 s 6 hours and it stretched the chain so much i knew something was wrong i figured out #35 clutch with a 420 chain doesn't last long their warranty sucks !!!!!!!!!

[@Canadian_Craftsman]

Pretty surprised actually, was there a noticeable feel in power or barely?? Makes sense the longer tube helps optimize fuel!!🤪✊️🔥

[@NVScrapper]

Good video, I like that bike!

[@Black66]

Thanks!

[@paulluffman519]

I am running a 10 tooth Max Torx clutch. 60 tooth rear sprocket. Strong Tillotson 212. 67 mph. I love my Coleman ct200uex

[@Black66]

Nice! Check out the playlist. We get the Colemans into the 60's. kzbin.info/www/bejne/jmG2nnSQf5ukjZo

[@paulluffman519]

@@Black66 I actually let off of the gas. It runs unbelievably fast. I won't hold it wide open. I have got to put front brakes on it. It is too scary with just the back brakes.

[@Black66]

@@paulluffman519 I really like the CT200U-EX bikes but I also like my e-bikes. Check out the e-bike race videos. We race a couple CT200U=EX minibikes. kzbin.info/www/bejne/pWG4nZyKiLiqjcU

[@paulluffman519]

@@Black66 I couldn't believe how fast they was. I have three friends that lost their leg from car's pulling out in front of them. I got lucky, I crushed my foot and ankle and they was able to fix it with screws. I mainly used front brakes after that. I'm paranoid running too fast with back brakes.

[@Black66]

@@paulluffman519 Ya, I don't blame you. Definately have to be careful out there. Especially as fast as these bikes are getting these days.

[@samsgarage1716]

Good information.

[@Tampaboys]

Good stuff bud

[@phat-kid]

probably just adjusting the carb needle would make up for the difference. i bet the only difference is it needs to be tuned. i bet it would actually run better with the short intake if you tuned it, but who knows. not enough of a difference to really matter anyway. it would make a big difference if you were going from a bent intake to a straight one with no turbulence. that's why i'm putting a short intake on my bike.

[@Black66]

Check out the CT200U-EX playlist for many engine and part combos with this bike kzbin.info/www/bejne/m3nEqWyBjqhjrtE

[@str8xrippin]

I've always believed shorter ram intake makes more power overall and I run a shorty on my bike

[@babyboy3972]

I think it has more power with the open header and no muffler on it

[@mikesbarn1858]

I wonder if the fuel/ air isn’t mixing as well with a short intake.

[@Canadian_Craftsman]

Short answer yes longer intake tube helps better fuel optimization!!

[@predator_boiz336]

Is that a predator 212 on this Coleman or the stock (now modded) 200 motor??

[@Black66]

It has had many different engines. This one is a modded 212. Check out the CT200U-EX playlist for many different engine and part combos with this bike. kzbin.info/www/bejne/jmG2nnSQf5ukjZo

[@nuggetfury216]

Hey Black66 love the video quick question I have a mini bike with a Honda GX390 and I don't know what type of clutch system I should use. Do you recommend a torque converter or a clutch and if possible what brand?

[@Black66]

Everyone is different but for me I like a torque converter on the bigger bikes like the Coleman CT200U-EX and a clutch /chain set up on the smaller bikes. GoPowerSports has a nice 40 series that will handle anywhere from 8hp to 18hp .

[@nuggetfury216]

@@Black66 awesome man thanks for the info 🙏

[@johnk6346]

🤠👍

[@Jrocklife]

What air filter is that??

[@Black66]

Its a filter I picked up from an ebay seller.

[@NickDustin-sr7gw]

What app do you use for your speed

[@Black66]

I use digiHUD for top speed along with the camera GPS and I use a Dragy performance meter for 0 to 30

[@NickDustin-sr7gw]

Thx love video

[@Black66]

@@NickDustin-sr7gw Check out the CT200U-EX playlist for many combos and videos with this bike. kzbin.info/www/bejne/jmG2nnSQf5ukjZo

[@Jrocklife]

1st

[@ionhunter]

[@DJ-xo4jg]

Hey man, go power sports has a stage 1 bolt kit for the juggernaut. It's like $40. Any way you can test it out and make a video. There's not much info I can find as far as a review goes.

[@Black66]

Yes, I'll see if I can do it. Thanks!

[@DJ-xo4jg]

@Black66 awesome.