Which WET SAW should you BUY?

Рет қаралды 13,062

Күн бұрын

Пікірлер: 13

@Phil-iv9oz 4 ай бұрын

I appreciated your video. I wasn't sure which Rigid saw to get. You're leaning toward the stand-up. I also noticed buyers giving the stand-up a slightly better rating

@RELAXnRENOVATE 4 ай бұрын

@@Phil-iv9oz thanks for watching. I do lean more towards the stand up since I do a lot of tile installations. It’s versatile. If I were doing smaller tiles a lot, I would probably consider the bench top.

@isaiahhartwell9612 Жыл бұрын

My bathroom 9x10 ,floor, inside shower, I'm using 9"x9" hexagon, just to do work around the house, which saw would be a better fit.

@RELAXnRENOVATE Жыл бұрын

You’ll make cuts more quickly with the larger one. The smaller table saw is great for ceramic subway tiles…..I pasted the link below to Home Depot. I couldn’t find it cheaper on Amazon but maybe you can. Hope that helps! www.homedepot.com/p/RIDGID-9-Amp-Corded-7-in-Wet-Tile-Saw-with-Stand-R4031S/307346631

@jordannoll6830 7 ай бұрын

Thanks for the video. Can you cut 12" x 24" tile on the table top version?

@RELAXnRENOVATE 7 ай бұрын

You’re welcome! Yes you can, it takes a little finess since the table jogs a little bit at the end. I go over that issue in the video. Once you get the hang of it, it’s easy. If you want a perfect running saw without some quirks, this one might not be a good fit for some people.

@OMG3Dmax 4 ай бұрын

cat watching what happen 7:35

@franklinanderson7389 3 ай бұрын

You need a better blade on that table top.

@RELAXnRENOVATE 3 ай бұрын

I know! Tell me about it.

@gateslattes4686 2 жыл бұрын

Don’t know what to get Ridgid wet saw or the sigma tile cutter

@RELAXnRENOVATE 2 жыл бұрын

Ohh I guess that would depend on what your job requires. I prefer the wet saw if I need to make clean finished edge cuts like when I do shower stall or backsplash work where the tile edge will show. However, If I’m doing a tile floor where the edges of the cut tile will likely be covered by baseboard for example, then I often use a tile scribe cutter, like the sigma. I hope that’s helpful. Thanks for watching and for the comment!