First conect the Green wire (ground) second the white wire (neutro) , red and black last
@romerojosh035 жыл бұрын
Do you need any specific type of foam strip? Such as like a high heat?
@wills4544 Жыл бұрын
Just bought a new cooktop made by Whirlpool, but the instruction of install the adhesive foam strips is as following: "Apply the foam strip adhesive around bottom of the four edges of the cooktop glass, following the edges of the glass." But you put them on the metal parts instead of glass? Which way is correct? Thanks!
@anonymousperson4363 Жыл бұрын
The ground should be connected to the box.
@vkulanthaivel5 жыл бұрын
Where do I get the exact same base cabinet? Is it pre-assembled?
@BillClay884 жыл бұрын
Just did it. Pretty easy. Well, really easy. &1400 bucks though.. 100 bucks extra for chrome trim that's only on two sides as we see. Not a complete frame. What a waste of money.. I just would of went blacked out, but dad paid for it. Thx, dad.
@jamesmart96474 жыл бұрын
From the cook top have a red white black and ground wire from the power supply white black and ground what’s the right Sequence
@bedwarskeed11043 жыл бұрын
Is there a male adapter for the flex? Or would the whole flex have to be replaced in order to have a way to disconnect?
@fitmedicscoaching72484 жыл бұрын
If installing this on quartz, is there another method of securing it underneath with the brackets and screws? Or just snug the screw up to the granite but not tighten?
@binhminh4175 жыл бұрын
Thank you!
@satoboshi116 жыл бұрын
Hi, Should the cooktop have a support underneath in the middle? otherwise if you place a heavy pot in the middle, this will crack like a cookie.
@WhirlpoolServiceAndSupport6 жыл бұрын
Hello, as long as the cooktop is installed in compliance with the Installation Guide and used with information from the Use & Care Guide, We would suggest checking the Use & Care guide before purchasing so you can check on things like pot size and canning notes.
@aBoogivogi5 жыл бұрын
@Σκληρός Καριόλης There was a metal lip running underneath the glass. My guess is this is what's actually holding up the top and not the glass plate. Also I'm guessing any wooden supports under there can pose a fire hazard if the casing gets hot while the top is in use.
@curioushooter6 жыл бұрын
Jeeze...you twist wires together before twisting on the wire nut!
@weaponizedmemes34616 жыл бұрын
Wrong. Common mistake. Twisting them (too much) before twisting the nut can get the wires. Just place the wires side-by-side, place wire nut, then twist.
@DirkGorgiel3 жыл бұрын
For a German's eye it looks so hazardous with wire nuts. We prefer German hightech, WAGO. Think; your "paper houses" burn down, quickly.