White's XLT - faulty

Anyone seen this error before?

[@jonmalco]

Found out the problem was that the field next to me had a electric fence that was causing interference. Detector is fine :)

[@kwaisanglee2]

Why take my earlier comment off?we are just trying to help.If your detector is having the problem demonstrated by the speaker all you have to do is give your detector mother board a good clean especially around the battery contacts.I hope this will help you to mend your detector.Please give me a thumb's up .

[@chihene]

If you can find a JImmy Sierra Eliminator coil ...get it...it works fine around electric lines and it gives greater depth that you would expect from a 6 inch coil...you can also get great performance around fences and playground equipment...I have seen these sold on ebay from 25.00 to 300.00...I remember seeing them sold in the USA for 159.00...this is a great coil for the xlt.

[@MichiganCoinHunter]

1. Turn unit ON 2. With power ON, remove battery pack 3. Wait 60 seconds 4. Reinstall batteries The above does a "hard reset" and "synchs up" XLT. If that doesn't help try a different coil. It may of gone bad. You might be just picking up EMI interference. Try a new area.

[@خالدالمراعيه]

Did you find the problem my friend or not? I have the same problem, tell me

[@drew7473]

them xlt's are build to last. i.love my xlt

[@خالدالمراعيه]

Did you find the problem my friend? Tell me

[@kwaisanglee6909]

Did you not read my comment?

[@haidaros3934]

hello guys my xlt i turned it on and the screen on light green with peep sound and goes off it seems a battery dying plz help??

[@kwaisanglee6909]

I've never encountered this problem.My guess is some components may be sticking to each other like the resistors.Just give the board a good clean and you may have to use a tooth brush and contact cleaner.you may have to take the screws off,but be careful you may break the battery contacts.

[@kwaisanglee6909]

You have a battery problem.Get the battery pack replaced or recharged fully.

[@johngifford8335]

Remove the coil cover and clean it.

[@timmeyer4474]

sinsativity too high