Whitfield Advantage Pellet Stove Proof of Fire (POF) Low-Limit Sensor Replacement Tutorial

This is a tutorial video on how to replace the proof of fire (POF) sensor on a Whitfield Advantage pellet stove.
Here is the affiliate link for the Whitfield Proof of Fire (POF) Switch if you are interested in purchasing: bit.ly/3VPTKh2
We are in partner with a number of affiliate programs, and we do receive a commission through these organizations. Hopefully this helps in your repairs! Thanks for watching!
Does your pellet stove start up, light pellets on fire, but shuts down after a bit? More than likely your proof of fire sensor will need to be cleaned or replaced if your stove has a POF sensor like the one shown in this video.
Please like, share and subscribe! 🔥
Check out our selection of pellet stoves, parts, tools and more at our website!
www.milespelle...
*Remember to always UNPLUG your pellet stove prior to performing maintenance. We do not assume any responsibility for people attempting work on their own or others’ stoves.

[@MilesPelletStoves]

Here is the affiliate link for the Whitfield Proof of Fire (POF) Switch if you are interested in purchasing: bit.ly/3VPTKh2 We are in partner with a number of affiliate programs, and we do receive a commission through these organizations. Hopefully this helps in your repairs! Thanks for watching!

[@davekauffman8727]

I've never heard the name "Brakes" before, but that was a good thing to show how to fix.

[@MilesPelletStoves]

Appreciate the feedback.

[@edbauer8790]

Thank you great video

[@MilesPelletStoves]

Always welcome Ed. Please Subscribe Thank You Brett and Briggs

[@brianmartel7432]

My blower will turn off but the fire is still burning. Meaning the auger continues to feed pellets blower goes off then fills the house with smoke. Does this sound like a low limit issue?

[@MilesPelletStoves]

Might be based on your comments. If your limit switch on the exhaust blower is not topical....remove switch and use a little sand paper to clean off the back side. Re install and see if this helps. Please Subscribe Thank You Brett and Briggs

[@iCreateProduction]

Hey mine was switched to a topical and they moved the topical over towards the control panel and screwed it in. Would it be better to replace that topical or go the old fashioned way and throw one in the exhaust

[@MilesPelletStoves]

Old way is best. Please Subscribe Thank You Brett and Briggs

[@iCreateProduction]

@ where can I get the wires? The wires must have been changed and are now too short to reach the blower motor side. Wish I could show pictures on here

[@MilesPelletStoves]

​@@iCreateProduction Go to auto parts store and buy extra wire and connectors