How to wire a 2-speed wiper motor with the park feature using toggle switch 5-pin relay and a diode from a 1981 Honda CB750.
Пікірлер: 8
@Mightyz71 Жыл бұрын
Awesome!!... just exactly what I was looking for... thanks
@WJonez Жыл бұрын
You're welcome, I hope it worked for you.
@slickmick18668 ай бұрын
What is the diode for? And if I don’t have one, what do I do?
@WJonez8 ай бұрын
The diode is used for a back feeding problem. When the motor is in the high side; the wiper arm comes around to the part feature and slows down then speeds up. So the diode prevents the wiper motor from slowing down when the switch is in high. The park feature in a nutshell; is a ground, but it’s also an open circuit. As the motor is turning, the park feature changes from open circuit, ground, open circuit. If I had another motor, I probably could wire it without the diode, but I don’t have another motor.
@terryhodges2782 Жыл бұрын
The diagram was too fuzzy to see can you post it here in the comments?
@WJonez Жыл бұрын
I can, I just have to figure out how to post a picture to the comment. I’ve never posted a picture in comments. I’ll see what I can do. It may take me a minute.
@terryhodges2782 Жыл бұрын
would it help if I sent my email to you?@@WJonez
@WJonez Жыл бұрын
kzbin.info/www/bejne/hXPLgWWphq94pKssi=RZtV246chlht8Jct I could not post a picture in the comment, I made a 1-minute video.