Wiring harness routing on inner fender Wife's 1955 Chevy project

Figuring out how I'm going to run the harness and other stuff.

[@hubiesgarage]

I like getting rid of the "not so well thought out" parts that the factory used on these cars. I have had tons of cuts on these parts over the years and it is time to eliminate them, especially those wire harnes clips! Watching these episodes have reminded me of that! Great video and keep up the great work!

[@haffrods7055]

Out with the mass produced and in with the custom. Lol

[@johnkranz4004]

Looks good nice ideas for the wiring

[@haffrods7055]

Thanks John

[@laynelommen9460]

You do nice work.

[@mikes55chevygarage86]

That's going to look so much better

[@haffrods7055]

I hope so Mike. I sure did put too much thought into it. Lol

[@ronlynch7744]

😎👍😎

[@paulcochran1721]

Instead of welding nuts to the back of the fenders, have you considered nutserts? Super clean and install like a rivet.

[@haffrods7055]

I have used them before but don't have any or the tool. I have plenty of nuts and a welder.

[@paulcochran1721]

@@haffrods7055 Well, your results on the black car speak for themselves! Outstanding!

[@Clikclikboom]

Lotta good ideas .. thanks

[@haffrods7055]

Thanks Tim