Witchdoctor's How To- Running board turn signals on a Victory

[@aarondickey4116]

What is your part number for these led running board strips. I went to your website and cannot find them. Thanks. It's for a 2015 Victory CCT.

[@witchdoctorbillet]

I will put it on the list.

[@bikeracr]

Hello I have a 2007 Jackpot ,the same bike you used in the EZ-pull clucth arm install vidio,I have bought LED front turn signals to replace the oem and I also have got load resister's so they flash correctly but have no idea hot to wire the load resistor's in with the oem wiring do you have a vidio on this ? or could you just offer me help ?

[@vsrhk]

jon, can you make a video on how to install a load equalizer on these LEDs? the LEDs work when the ignition is off. but once i've turned on my engine, the LEDs including the existing signals cease to work. thanks!

[@rlmyers2946]

I have the same problem. Where's the video?

[@rebeccabaumgartner6396]

I have the same problem with mine, how do you fix it?

[@nomadsmg1]

When I installed additional led turn signals I had the exact same problem. Our bikes have a computer based turn signal system. If it don't see the factory light and only the factory lights it shuts down. Here is another Victory Owners solution to get around the problem, you'll find it about halfway down, he was installing LED Mirrors and ran into the same problem. www.billanddot.com/adding-rivco-led-mirrors.html

[@notjaysday]

Oddly, he specifically says that load equalizers are not needed... But they actually are?

[@witchdoctorbillet]

You can use grommets. We just did it with silicone instead.

[@nomadsmg1]

When I installed additional led turn signals, both the additional and OEM Turn Signals stopped working. Turns out the 2012 Cross Country with original Factory LED Turn Signals have a computer based turn signal system. If it don't see the factory light and only the factory lights it shuts down. Here is another Victory Owners solution to get around the problem, you'll find it about halfway down, he was installing LED Mirrors and ran into the same problem. www.billanddot.com/adding-rivco-led-mirrors.html

[@witchdoctorbillet]

It sounds like you may need a load equalizer.

[@rlmyers2946]

you never suggested you need anything else when you were selling this item. I have the same problem as Simon Wan. Could you suggest what else I need or do I need to send them back to you and never order anything else!!