Рет қаралды 4,298
www.AsWoodTurn...
I started turning this vase shortly after receiving it in a club wood raffle. It was still wet. It seemed to be perfect for a hollow form turning. I rough turned the outside and hollowed it while still green.
After coating it with a PVA based wood sealer from Craft Supplies USA, I let it dry for about 18 months. I weighed it periodically to assess how much moisture had been lost.
Remounting a dry but warped project is always part of the challenge. In this case I had placed a scrap disk over the entry to the inside to limit air movement. This now served as a tenon while I recut a tenon on the base.
Then on to cut off the sealer and trim the hollow form to final shape. I wanted a smooth curve.
In this case I used a sanding pad to remove the last of the nub on the bottom. I put the sanding pad in a #2 Morse taper collet sized to the pad's shaft. Then a drawbar holds the collet securely to the spindle. This works better than a Jacobs chuck in the spindle.
This vase is finished with walnut oil.It measures about 6 inches in diameter and 5 inches tall.
Enjoy!
Blog: www.AsWoodTurn...
FB: / aswoodturns
InstaGram: www.Instgram.co...
#vase #hollowForm #greenWood #woodworking #woodturning #woodturningprojects #lathe #AlanStratton #video #DIY