Working On The Trikes Rear Axle

I have had trouble trying to get a video out, think I have the problem solved, hope this works.
In this Video, I clean up parts, and strip the paint off the rear axle assembly.

[@jenkinsdale5]

Like and subscribed just because of the tip about the key, saved me a lot of blood, sweat, and tears

[@sneezyferret6482]

Thanks for this, now I understand how the axle comes apart. I have to replace the freesheel on our 7 speed e-trike.

[@LorisRVLife]

Good Morning!! Glad to see you back :)

[@antoniojimenezgt6086]

Nice video man

[@hanschitzlinger3676]

I have the same trike. I’m putting a 212cc motor on it. Lots of good info here

[@tbronson158]

i cant get those end bearing out , have tried cold and hot and using slide hammer . its like its welded in the axle casing

[@Vidar.m]

Could be a cool e-bike

[@loufernando7617]

Thx

[@Quasilobo]

Thx! Interesting project. Never saw a disk brake on a 3-wheeler before. Good idea. Actually I was looking for some guidance on removing / replacing the ball bearings in the tube. Did U use a puller or a long drift to get them out? It didn't look like the bearings were a press fit onto the axle shaft. I'm refurbishing a Miami Sun (3-wheel) that sat in an unheated (Michigan) garage for years. The grease in the bearings has turned hard like plastic. They're clicking and popping and squealing. Pls advise.

[@astutenomad2879]

Where did you order the 17mm axle? I know those Schwinn Meridians come with 17mm axles NOT 5/8". The 17mm axle is combined with 4 6003rs bearings.

[@antoniojimenezgt6086]

Hey can you make a tricycle rear wheele spin the same time like rear wheel drive cars

[@ybboboportoselaznog341]

What size bearing axle

[@vidalroman2213]

I need that same real axle where do I order it from