Worst mistakes when installing toyota hybrid battery

Most common mistakes when you installing a new or used toyota hybrid battery so please follow this tips to avoid damages in your hybrid battery.
Don't forget to please like and subscribe in our amazing Hybrid Solution Diagnostics TikTok in the link bellow:
www.tiktok.com/@hybridsolutio...

[@beechizel8148]

After watching so many videos I thought I captured all the important stuff but learning about these corroded cables likely just saved me a lot of grief. Thanks again

[@reggieflanders9865]

Hello , Jose I have been watching you for about 2 years now I personally think you make the most reliable videos and Helpful information . So , I am fixing my 2012 Prius V . Because The Dreaded Light came on and my car died at 200,000 miles . I found out the 12 V Battery was dead and replaced it . And the car started and drove fine but then the Light came back on at 205,000 miles the code said I needed to Replace the Hybrid Battery Pack . So in April 2023 I used my Think-car 7S Plus Scanner to Diagnose the issue and the Dr Prius Updated app . I found Block 1 Was bad and Replaced 2 Cells and it still showed bad . I thought I replaced the correct cells in Block 1 but found out now it was Block 14 cells that I replaced by mistake . I wasted all that time and effort because I did not know the correct location of the cells and the Blocks on my 2012 Prius V Hybrid pack . I just found out that Block 14 is actually Cells 1 and 2 on A Prius V 2012 . The cells start from the electronics side or Passenger side (1-28) on a 2012 Prius V . But the Blocks start from the opposite side or Drivers side . Which meant I replaced Block 14 ( Cells 1 and 2 ) Not Block 1 (cells 27 and 28 ) causing me to get the same error as before . I have not found any Video's showing the Block to Cell configurations on Here and Was Hoping you could make a comment or Video about what Cell corresponds to what Block and what are the Locations of the Blocks Such as on a Prius 2008 etc.. and others such as like mine a 2010-2015 Prius V . And How to Test each cell and Completely Check if the Used Replacement cell is good or not or just a waste of time . and We will be able to know what Cell on Dr Prius Belongs to what Block on the Battery and what is the Location of each Block and if the cell is good or bad . It would help so so Much as all your Video's do . If I had Just Known the crazy configuration of Block 1 was cells 27 and 28 and not cells 1 and 2 . So I hope you can help others in the same boat as I was . Thanks Reggie

[@sanfredsmith3023]

Thank you Jose, I have been watching your videos for more than a year now and I am still learnin everytime you post up a new one, thank you for sharing your kinowledge.

[@d-s-ll2378]

Valuable. Valuable teaching!😮

[@ebb2421]

Should also mention the corrosion getting into the battery ECU and triggering fires. The battery main vents don't work. The negative post seal fails before the main vent and that causes all the damage. There should be a class action suit...

[@selinavunisa2473]

Thnx for the info🎉

[@advancedleveldiagnostics]

Great tips, Thanks!

[@hybridsolutiondiagnostics]

Glad it was helpful!😅

[@mmoon1860]

Excellent informations thank you 🙏

[@hybridsolutiondiagnostics]

Glad it was helpful!

[@wimschoenmakers5463]

Great video! Interesting topic! 👍

[@hybridsolutiondiagnostics]

Thanks 🙏

[@rexcavanagh9837]

hi good video just wondering where you buy a new earth cable thanks

[@InokeCaudremalua-tj6zq]

Thank you

[@edbeck1029]

thanks for posting this video. Where can I buy these hybrid battery electrical cables ....the orange ones that get corroded over time? I can only find them used as on eBay. I want to purchase new ones. thanks ed

[@behunin1963]

Love your videos, very informative, very practical in approach. I understand for video teaching it is best to have the entire battery out for service but can a battery service be completed by removing the top shell then replacing the cells or modules and then replacing the connections and top shell? (Highlander or RX400h) thx so much.

[@hybridsolutiondiagnostics]

It is always good to have a deep cleaning of the battery...

[@mauriciotoscano6968]

Jose. Just found your videos and hands down the best videos on Hybrid Batteries. I'm a DIYer and have been having recurring problems on the same battery pack, even after changing all the bus bars and nuts. I was on the suspicion that the corrosion on the cables was the problem and just order new ones. I haven't gotten them yet to try, but after watching this video, I'm more convinced that will solve the problem. Great work!!!!!! and superb explanations.

[@hybridsolutiondiagnostics]

Thank you Mauricio, glad you liked it…

[@newmankramer1903]

How did it go?

[@edbeck1029]

where did you purchase new cables? thanks, ed

[@mauriciotoscano6968]

@@edbeck1029 got them on eBay, but din't fix my problem. It turned out to be the hybrid voltage sensor battery computer which I got on Ebay too and solved my problem.

[@JorgeRamirez-dp4pf]

Saludos profe desde Montebello California

[@hybridsolutiondiagnostics]

Saludos hermano 🙏🙏🙏

[@bepinos]

Hello Jose can you pls assist with the requirements you use to setup the cycling of a battery using the prolong equipment. I am living in New Zealand. Thankyou

[@nissanzamyadtech.4856]

Hello. Josey I have been waiting for your new videos.

[@hybridsolutiondiagnostics]

☝️🥲🤣🤣🤣

[@sultanmahmud6871]

Man, I need one suggestion from you regarding break oil maintenance for my Toyota hybrid fielder 2016. Here in Bangladesh mechanic doesn't have much idea. Car users often suffers with break booster problem and ends up destroying break booster. Can you please let me know the exact maintenance for break system like when to change break fluid, and break shoe so that I don't have face break booster problem for my Toyota hybrid fielder 2016 ???

[@renzokuken1227]

whats the best way to replace the cables? im fixing to work on my 2007 prius. should i go through dealer or is there some other reputable site?

[@jayrod9183]

What is the name of that cable?

[@Pred-atoyz_2023]

hola jose! gracias por tus videos son de mucha ayuda, tengo un 2007 camry hybrid el cual no puedo hacer que funcione correctamente, mi scanner me dice que block 2 y 3 no funcionan, ok, los cambio pero no resolvio el problema, los cambio de nuevo y esta vez remuevo todas las celdas y hago un load test, reemplazo todas las celdas mas bajas, las balanceo, todas marcan 8.2 volts, instalo todo de nuevo asegurando de limpiar terminales,etc nuevas bus bars y tuercas, y resulta que no se resuelve mi problema, uso dr prius y cuando monitoreo la bateria los bloques 2 y 3 suben y bajan en verde pero bajan hasta abajo en rojo, que puedo hacer? la luz roja en el dashboard ahora prende y apaga en intervalos de 10 seguntos mas o menos. gracias por tu ayuda. por cierto mi carro se apaga manejando,y al parecer cuando esta en con los codigos el motor electrico parece no ayudarle al de gas y el carro esta lento, por favor ayuda ya trate varias cosas.

[@justinweavers2781]

Hi there your videos are great! I am checking a P0AA6 code on my 2008 prius. I took out the HV battery and there was a bunch or corrosion, following your video on how to do that👍🏻. But my question is, will i need to re balance my battery or charge it in anyway or can i just put the battery back and let the car charge on its own? Also the P0AA6 comes on in park without the engine on so it’s not transaxle or inverter, definitely battery/wiring.

[@hybridsolutiondiagnostics]

Yes, it could be a bad signal due to that stupid corrosion… so have it a visual inspect and some measurements

[@steves7973]

Good tip re battery cable corrosion, seen this a lot on lead acid battery systems and the cable is not repairable.

[@hybridsolutiondiagnostics]

Yes, it must be replaced

[@hybridsolutiondiagnostics]

@@alext8828 is it too difficult to believe the both actually happen! 🧐🧐🤣🤣🤣🤣🤣

[@renatawaithe3311]

Hello, great video thank you. Would you be able to do a video on the new Nissan e-power systems?

[@hybridsolutiondiagnostics]

We have already… very in-depth

[@renatawaithe3311]

@@hybridsolutiondiagnosticsthanks for the response. I had a look at them after commenting. Is the newer e-power systems the same as the one you reviewed?

[@mattcongiusta]

how are you finding the reliability of Nexcell/Project Lithium Batteries? as long as there is not any corrosion on the have the batteries them self proven to be reliable ?

[@hybridsolutiondiagnostics]

So far so good with nexcell… 😎👍 too soon to say yet… let those batteries for 2 more years and we will see 👊😁🔋🔋🔋🪫🪫🪫🪫💥💥💥💥💥💥💥

[@mattcongiusta]

@@hybridsolutiondiagnostics thanks for update i heard ppl are getting 10% better fuel economy on nexcell i guess it all depends how you drive

[@mauriciotoscano6968]

@@hybridsolutiondiagnostics I believe the hard part is getting the Nexcell/Project Lithium modules. I have been trying to get some for the last 6 months and their website keeps on saying "Sold Out" Any insights on where to get them Jose?

[@agboolanajeem5268]

👍👍👍👍

[@mauriziogiasan4411]

king❤

[@angelnegron3460]

When you are replacing your battery modules with new litium modules, do you have to charge the battery after installation and dischage it.

[@hybridsolutiondiagnostics]

Not necessarily ☝️😎

[@OGATOSAI1]

Hello Jose did you do any online courses

[@aa-dz6cr]

Dr Prius app measures internal resistance and gives a reading for each module. Is there a maximum reading. I ask because I've already installed the Nexcell in an 08 Prius and I'd like to make sure I didn't mess up. I don't think so but I did use the original harness (cleaned connections).

[@aa-dz6cr]

I drove the car today and internal resistance was between 13 & 15 milli-ohms. Battery temp was 95.8, 95.6 & 92.5 Ferenheit. Blade voltage was 8.14 with .04 Volt Diff. That all seems good. Is there anything else critical on a new battery?

[@christopher6161]

Where should we buy replacement cables, is used ok

[@hybridsolutiondiagnostics]

New or used in good conditions should work just fine

[@TBoneSteele]

HOW CAN I WATCH THESE VIDEO'S IN ORDER?

[@kamaleloirdi5282]

Hello jose I have 2016 Hyundai sonata hybrid I got a code p0a81 And I take hybrid fan cooling blower motor out and clean it one month later code come back ,can u help plz ?thx in advance

[@hybridsolutiondiagnostics]

Replace the fan my friend…

[@kamaleloirdi5282]

Thx jose

[@doctorjekkil3813]

Too high volume music.

[@hybridsolutiondiagnostics]

Seriously brow… that’s just the intro… live happy and enjoy this free tech info… if not, then switch to another channel…

[@suvodas523]

1.POAA649 Hybrid/EV Battery Voltage System Isolation Internal Electronic Failure Pending 2P0AA649 Hybrid/EV Battery Voltage System Isolation Internal Electronic Failure Confirmed

[@suvodas523]

Sir how to solution that this code

[@user-zu7pw2ee2i]

U are talking to much,get to the point.

[@perniciousprogressive8333]

Always good info, but ya could've dropped the entire first third of the video...

[@hybridsolutiondiagnostics]

Yeah I know… I talk a lot ☝️😁💥💥💥💥

[@perniciousprogressive8333]

@@hybridsolutiondiagnostics yeah, I too suffer from loving the sound of my own voice. My wife of 35 years has been quietly planning my demise for most of that time for that very reason, which is why I sleep with one eye open. 😉