XSY-AT1 VFD Variable Frequency Drive Remote Panel Programming

I've made a panel so I can control my VFD remotely, simple set up for run/stop, forward/reverse and variable speed.
I have used a couple of toggle switches and a 10kohm potentiometer.
My VFD is manufactured by XinShuangYuan Co LTD in China.

[@user-ef7gw5pg2l]

Thank you for making the addition of controls to the VFD so easy to understand. I have looked at a number of videos and most talk about alot of BS and not the practical part of adding the VFD to an existing machine.

[@bodganeering]

Glad it was helpful!

[@lucapalermo29]

Great 👍 please can you show ke how connect Star and stop in the panel ?🙏

[@sarkistatuljan2950]

One question - can you program the XSY-AT1 VFD Variable Frequency Drive so that it runs at high speed for about 2-3 minutes at the beginning, but closer to fixed low speed?

[@bodganeering]

I don’t think this unit has that flexibility as there’s no timer on the system.

[@lucapalermo29]

I bought an start & stop button all in one but before i connect potenciometer and reverse direction 3 button 1-0-2 But if i want use specific button i must to connect a bridge from this one reverse control to start & stop to activate?

[@bodganeering]

The manufacturers instructions aren't very clear and show the wiring connections the wrong way round. You will need a wire from the COM to both switches, either from the VFD or bridged from the switches. Then run a separate wire from each switch, START/STOP to X4 and Forward/Reverse to X6. X4 will need to be programmed as I show at around 1:30. X6 is already programmed by the manufacturer so you shouldn't need to change anything on the VFD. If you look at the picture at 2:11 you can see the wires I have connected. RED/BROWN from COM to switches. WHITE for START/STOP and Green for FORWARD/REVERSE. BLACK, BLUE and YELLOW are for the potentiometer. Hope this helps.

[@user-xx2wk6jp5d]

Hi can you please help i have a cross cut saw and need to put in a two way switch so that i can have it running continuously or on the hand button stop&start also i need to put in an emergency stop

[@bodganeering]

Sorry, but it wrong be wrong to give out 'how to' advice on wiring machines up especially safety circuits, I would recommend you consult a qualified electrician to assist you in this. As I state on my channel information and in my videos this is how I do things and professional advice should always be sought.

[@HVACOOL]

What fault FC002? Please

[@bodganeering]

Looks like under voltage. Your supply voltage is too low.

[@HVACOOL]

@@bodganeering cant change display coz setting unfungction?

[@bodganeering]

I would suggest contacting the manufacturer.