this video was created for a specific person to use but I'll make it a public video just in case this helps somebody in the future.
Пікірлер: 14
@brianwichner49986 ай бұрын
Awesome video, it is really useful to see all the different parts of the engine. I had an oil leak and i hope it's fixed. The oil filter was rusty, especially at the base. I needed a razor blade to scrape that seating surface to clean it. After i did this, i noticed the bilge had some oil. I cleaned that up. Ran the ski in the ocean for an hour or two and just a little oil in the bilge. Maybe residue from before. I have a 2014 vx110
@AndTodaysProjectIs6 ай бұрын
I'm really glad this video helped you! It definitely helps to see someone run a camera around the parts to gain the confidence that a person can do this themselves
@randyhernandez6519 Жыл бұрын
Hello, I stumbled on your page and I'm enjoying your content. Any advice for yamaha vx110 2005 milky oil, (most likely self induced with water hose on while motor off) been flushing and more flushing oil. Any pointers?
@AndTodaysProjectIs Жыл бұрын
Best suggestion I can give is visit the pwc repair forum at www.greenhulk.net and use the search feature. There is a ton of advice on this. Most say 5 oil changes. On the last oil change, also change the fter and then run the shit out of it on the water and the remaining slight milkiness will vaporize and the oil will be clean again.
@randyhernandez6519 Жыл бұрын
@@AndTodaysProjectIs thank you very much
@leonardomedrano8377 Жыл бұрын
Can you please upload a full video on how to remove the oil pump? Can’t remove mines.
@AndTodaysProjectIs8 ай бұрын
I'll try to remember to do one of those in the future. None pending right now
@coastcafeequipment Жыл бұрын
Very informative video,thank you very much. however I feel dizzy now !! Can we start a go fund me page for a stand for your camera? 😀
@AndTodaysProjectIs Жыл бұрын
Yes you can! Ha!
@tac4bravo Жыл бұрын
I have 2006 yamaha FX HO. I had a ton of oil in the bilge and I think this video will help me. Do I need to drain the oil out before I pull that oil pump manifold assembly that you have here in the video?
@faisalhussaini971911 ай бұрын
What was the issue? I have same year with same oil in bulge
@AndTodaysProjectIs6 ай бұрын
You probably cannot remove the oil reservoir without removing the cylidner head off of the motor due to the configuration of the strap support that attaches this to the cylinder head being in the way. I believe you will have to pull the entire motor out to get this out of your ski
@JulianA-nn2dd10 ай бұрын
What type of sealant would you recommend reinstalling the oil pan?
@AndTodaysProjectIs8 ай бұрын
Hmmm, just fuel resistant black etc works fine. Surface prep is HUGE! Make sure they are clean and use plenty of brake cleaner and clean shop towels prior to mating surfaces. I suppose motoseal is good too